Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
1U Supermicro Server 10 Bay 2x Intel Xeon 3.3Ghz 8C 128GB RAM 480GB SSD 2x 10GBE
$273.00
1U 20" Short Depth Server Firewall PFSense X11SSH-F Xeon 3.5Ghz 32GB RAM NVME
$247.00
1U Supermicro Server X10DRU-i+ 2x Xeon Total 36 Cores 64GB 4x 10GBE-T 2PS
$314.00
Supermicro SYS-5019P-M Server Xeon Scalable 6138 20 Cores 40 Threads 48gb DDR4
$330.00
HP ProLiant Xeon E3-1220L V2 MicroServer Gen8 2.30 GHz 16 GB RAM NO DRIVES
$199.00
Genuine HP ProLiant MicroServer Gen8 Intel Pentium G2020T 2.5GHz 712318-001
$199.95
HP ProLiant Xeon E3-1220L V2 MicroServer Gen8 2.30 GHz 16 GB RAM NO DRIVESorCads
$200.00
CEOhack 1U X9DRW-3TF+ 4 Bay Server 64GB DDR3 1x E5-2667 V2 3.30GHz 8C 1x 1TB HDD
$119.00
1U BareMetal pfsense opnsense Router Firewall DNS Server 6x 10GB Ethernet Ports
$149.00
SUPERMICRO CSE-512 AMD Opteron Processor 6128, 32GB DDR3 RAM NO HDD
$90.00