ahhhahah same problem here i u figure it out tell me!!!!
I am using auditor which is built on knoppix and I am having problems putting my MA401 into monitor mode.
here is what I use:
iwconfig wlan0 monitor mode
error message I get:
Error for wireless request "set mode" (8B06) :
SET failed on device wlan0 ; operation not supported.
ahhhahah same problem here i u figure it out tell me!!!!
there is a thread on this on linuxquestions.org
did it work for you?, if so what thread helped you?
Hello,
"su" to root and iwconfig eth* mode monitor should work for you.
So, in your case, at the command line "su" , then enter root password if any.
Then do "iwconfig wlan0 mode monitor" , note the correct syntax, and without colons.
Br,
MrBean
ORICO Multi Bay RAID Hard Drive Enclosure USB 3.0/ Type-C For 2.5/3.5'' HDD SSDs
$179.99
ACASIS 2.5/3.5 inch 2 Bay SATA USB 3.0 Hard Drive Disk HDD SSD Enclosure 4 RAID
$55.45
Dell 7H4CN PERC H730P Raid Controller Mini Mono12GBPS 2GB NV Cache
$44.99
Yottamaster 2 Bay RAID Hard Drive Enclosure USB3.1 Type B For 3.5" inch SATA HDD
$75.99
Inspur LSI 9300-8i Raid Card 12Gbps HBA HDD Controller High Profile IT MODE
$15.98
LSI MegaRAID 9361-8i 12Gbps PCIe 3 x8 SATA SAS 3 8 Port RAID + BBU & CacheVault
$39.00
DELL PERC H310 RAID Controller with Cables, OHV52W, 6Gb/s SAS SATA PCIe x8
$19.95
Inspur LSI YZCA-00424-101 Raid Card 12Gbps HBA Controller Low Profile 9300-8i IT
$15.98
Yottamaster 2 Bay USB 3.1 RAID Hard Drive Enclosure For 2.5" SATA HDD SSD UASP
$59.99
Dell PERC V10 Z0017A SAS-SATA RAID Controller Card No Bracket N4C2D 5R10N
$52.97