I'm not a networking expert but think its stored under
/etc/init.d/networking
Hi all,
I am installing Gentoo, and using Knoppix to kick-start the install. I have managed to get to the point where I have to define all of the Networking Configuration in Gentoo. In Gentoo, according to the Install Handbook, everything is stored in /etc/conf.d/net. Unfortunately, Knoppix does not have an /etc/conf.d. My question is: where do I look in Knoppix for hints and how do I translate that into Gentoo-speak for all Networking.
Also important: I am currently installing on a box that is connected "directly to the Internet", through DHCP. I expect this one to be easy, as Knoppix detects everything without any trouble or input from me. I will be later doing this on a second box, where I first (under Knoppix) need to run the ADSL/PPPOE configuration - which works fine after I answer Yes to all questions, but where are the "results" stored.
Thank You.
I'm not a networking expert but think its stored under
/etc/init.d/networking
In case anyone is reading this, I found the answer to my question: the settings between the two are not compatible. Fortunately, Gentoo is well documented!
Cisco Catalyst C9300-24UX-A 24 Port 10G/mGig UPOE Network Switch, no module
$299.97
Cisco Catalyst C9300-24UX-A 24 Port 10G/mGig UPOE Network Switch + NM-8X Module
$599.97
Cisco WS-C3850-48P-L 48-Port Gigabit 3850 PoE Switch w/ 715W+ C3850-NM-4-1G Mod
$89.00
Cisco STACK-T4-3M Stacking Cable New Sealed
$149.00
Cisco WIC-1AM-V2 1-Port Analog V.92 Modem WAN Interface Card - 1 Year Warranty
$5.95
Cisco C3850-NM-4-10G 4 Port Network Exp.Module for 3850
$144.32
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
Cisco C3850-NM-2-10G Catalyst 3850 2 x 10GE Network Module
$34.00
Cisco Catalyst C9300-24UX-A 24 Port 10G/mGig Copper UPOE Network Switch
$375.00
Cisco Catalyst 2960-X WS-C2960X-48FPD-L 48 Port GigE PoE 2x 10G SFP+ Switch
$69.99