The question got answer in German Forum.
Problem caused by differnt settings of UTC within Host and Guest.
hi,
I installed some days ago koppix 6.7.3 in a VM, and today recognized, that time and date always shows the date/time from installationday. Therefore usenetpostings sent via knode to newsserver were cancelt because time/date are too old for acceptance. Trying to set up time/date manually via preferences failed and knoppix says, that I am not authorized to do this. No password will be asked, which should be necessary to become su for doing sysemchanges.
Whats to do, to make a timeserver work for knoppix to set right time/date?
regards
rudiratlos
The question got answer in German Forum.
Problem caused by differnt settings of UTC within Host and Guest.
ORICO Multi Bay RAID Hard Drive Enclosure USB 3.0/ Type-C For 2.5/3.5'' HDD SSDs
$179.99
ACASIS 2.5/3.5 inch 2 Bay SATA USB 3.0 Hard Drive Disk HDD SSD Enclosure 4 RAID
$55.45
Dell 7H4CN PERC H730P Raid Controller Mini Mono12GBPS 2GB NV Cache
$44.99
Lenovo 930-16i PCIe SAS RAID Controller FRU P/N: 01KN508 Tested Working
$149.99
Inspur LSI 9300-8i Raid Card 12Gbps HBA HDD Controller High Profile IT MODE
$15.98
Lot of 2 LSI MegaRaid SAS 9271-8i Dual Port SAS Controller UCS-RAID9271CV-8I
$24.99
LSI MegaRAID 9361-8i 12Gbps PCIe 3 x8 SATA SAS 3 8 Port RAID + BBU & CacheVault
$39.00
DELL PERC H310 RAID Controller with Cables, OHV52W, 6Gb/s SAS SATA PCIe x8
$19.95
Adaptec - ASR-7805 6Gbs SAS- PCI EXPRESS 3.0 X8 -1GB Cache RAID Controller Card
$33.28
Dell PERC V10 Z0017A SAS-SATA RAID Controller Card No Bracket N4C2D 5R10N
$52.97