Hi, I'm in need of a bit of assistance.
I'm trying to get knoppix (06-06-2003 build) to load up the driver for my New Media BASICS SCSI card on my Toshiba notebook (Satellite 1800). In the boot up sequence it recognizes the card but can't find the driver module (sym53c500_cs.o) on the cd. So I've tracked down a version of it (it's an old card and old driver so I'm not sure how well it will work, but it's all I can find), copied it to a floppy (which also has my config files saved to it), booted with the expert cheat code, and when it asked to load modules from the floppy it found the one it needed, but when cardmanager starts up it says it can't find the driver module. I'm new to Knoppix so I'm not sure if I'm doing something wrong, or if there is a problem loading a driver from the same disk as the config disk. Any help would be appreciated.
Two little side questions, if I boot with the expert cheat code, will the floppyconfig code still work and is there a particular order they need to be in. And if I get the SCSI card to work, will I need to use the expert code all the time or will a config save to the floppy have the driver location (ie. the floppy) recorded?
Thanks in advance.
Knoppix Live GNU Linux System 9.1 on Bootable CD / DVD / USB Flash Drive
$9.99
Knoppix 9.1 Live Linux GNU Bootable USB Flash Drive USA
$19.99
Linux Knoppix 4.0.2 Installation Disc
$39.99
Knoppix Linux Bootable OS v8.6 "Original Live Operating System" 32G USB Stick
$20.30
Knoppix 3.4 Linux installation CD
$15.00
$8.50
$8.50
KNOPPIX 9.1 LINUX INSTALL & LIVE DVD
$9.99
Acer Aspire One 9 inch Netbook ZG5 512MB RAM 8GB SSD HD Knoppix Linux WiFi VGA
$79.99
Knoppix Linux Bootable OS v8.6 "Original Live Operating System" 16G USB Stick
$19.95