I have the KNOPPIX image copied to a fat32 partition, the third partition on my second, slave, IDE drive, I think it is /dev/hdb3,
and can boot it from a floppy made using mkfloppy.bat.
Now, I want to install Lilo on the bootsector of this partition so I can dual boot using ntldr. I do NOT want to install Lilo to the MBR. Essentially, I want to follow the directions in http://www.knoppix.net/docs/index.php/HdBasedHowTo but they are so garbled, I don't want to try to follow them.
Has anyone done this? The obstacles are (1) I need to remount that partition rw, not ro. Then I need to install lilo. Then I need to configure lilo to load the vmlinuz that is there and to use the miniroot.gz as the initrd I think. But the devil is in the details. Clear instructions would be most appreciated.
Thanks
ARUBA J9772A 2530-48G PoE+ 48 PORT ETHERNET SWITCH W/ RACK EARS J9772-60301
$125.69
Fortinet FortiSwitch FS-124D-POE 24 Port Gigabit Ethernet Switch UNREGISTERED
$99.97
Cisco Small business SG300-28P Managed 28 Port Gigabit Ethernet Switch
$67.95
Dell PowerConnect 2848 48-Port Gigabit Managed Network Ethernet Switch
$49.99
NetGear ProSafe GS748T V4 48-Port Gigabit Smart Switch w/ Ears
$30.00
New Linksys SE3005 5-port Gigabit Ethernet Switch
$18.99
Linksys SE3008 8 Ports Rack Mountable Gigabit Ethernet Switch
$21.99
YuanLey 26 Port Ethernet Switch,with 24 port 10/100Mpbs poe,2 Gigabit Uplink
$31.00
Brocade ICX7250-48P-2X10G 48-Port PoE+ Ethernet Network Switch TESTED
$104.95
Dell X1018 X-Series Smart Managed Switches 16-Port Gigabit 2-Port SFP Switch
$65.00