Try this:
boot: knoppix lang=us xmodule=i810
You may need to add a screen size too.
I'm on an HP that is using intels 82810 graphics card... I was able to get x up and running once... in 640x480, but since then no luck! The screen just flickers... Any suggestions?
Try this:
boot: knoppix lang=us xmodule=i810
You may need to add a screen size too.
I tried the following:
knoppix lang=us xmodule=i810 screen=1024x768
with no success...
however...I can hear the startup sound (voice)...but can't see a thing...
There is an error right before x attemps to start, but the screen changes too quickly...is there a way to pause?
Also, is it normal to get the message "You passed an undefined mode number." right at the begining?
Thanks
No it is not try adding the cheat code vga=normal and maybe noddc.Originally Posted by jclochesy
I tried adding the vga=normal noddc, but it still behaved the same... The "You passed an undefined mode number" shows up even before uncompressing starts! It wants me to hit 'enter' or 'space'... 'enter' brings up a list of what looks like resolutions? I have no idea.
Also...is there a way to pause the screen so that I can read the message that appears later... when entering run level 5?
You could try knoppix-txt then when you get to the prompt then /etc/init.d/xsession start you may have to put sudo in front of the command it's been awhile so I can't be certain. Other than that have you tried to actually pass one of the numbers when it asks you too and see what happens with booting that way. You may also want to try as many of the cheat codes as possible and for sure just failsafe all alone on the command line to boot with minimal hardware detection.
I had a similar problem. I was trying to run Knoppix in failsafe. After a certain point the monitor kept going from "Power saving will be enabled" to a black screen, and back every split second. This repeated forever even when the system showed no sign of activity. Unfortunatly unless you are trying to run in failsafe I can not help you. The problem I had was a multiprocessor problem, which knoppix nosmp fixed. This was on a standard VGA monitor though.
Cisco SG300-52-Port Gigabit Managed Rack Mountable Network Switch
$44.95
ARUBA J9772A 2530-48G PoE+ 48 PORT ETHERNET SWITCH W/ RACK EARS J9772-60301
$140.23
HPE ARUBA 2530-24G J9773A PoE+ 24-PORT GIGABIT ETHERNET SWITCH J9773-60201
$93.24
Brocade ICX 7250-48 48-Port Gigabit Ethernet Network Switch | ICX7250-48-2X10G
$50.95
NETGEAR GS305300PAS 5 Port Gigabit Ethernet Unmanaged Switch
$22.99
HP ProCurve 2530-48G 48 Port Gigabit Ethernet Network Switch J9775A TESTED
$30.70
NETGEAR GS108 ProSafe 8-Port GbE Unmanaged Switch w/ Power Adapter
$14.99
Cisco SG300-10P 10x PoE RJ45 Gigabit Switch SRW2008P-K9 V03 + Power Adapter
$34.99
TRENDnet TEG-S17D 16-Port Gigabit Unmanaged Network Switch
$50.00
Fortinet FortiSwitch FS-124D-POE 24 Port Gigabit Ethernet Switch UNREGISTERED
$99.97