Brocade ICX6610-48 48-Port Gigabit Ethernet Network Switch w/Prem Router License For Sale

Brocade ICX6610-48 48-Port Gigabit Ethernet Network Switch w/Prem Router License
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Buy Now

Brocade ICX6610-48 48-Port Gigabit Ethernet Network Switch w/Prem Router License:
$139.99

TESTING & COSMETIC NOTES:
This is a USED WORKING item in GOOD cosmetic condition that IS THOROUGHLY TESTED and is GUARANTEED WORKING
The unit has been reset to the factory default settings. See console log below.

COMPONENTS INCLUDED IN THIS sale:• (1) - BROCADE ICX6610-48 48-PORT GIGABIT ETHERNET NETWORK SWITCH W/PREM ROUTER LICENSE
• (2) - BROCADE POWER SUPPLY
• (2) - POWER CORD

REPLACEMENT or MONEY BACK GUARANTEE:When you receive a Guaranteed item from OC Depot, it should perform as described. In the rare situation that this is not the case, we will send a replacement upon safe return of the original item within 30 days of receiving the item. If a replacement is not available we will honor the terms of our Money-Back Guarantee.

ADDITIONAL INFORMATION:UNIT 1: SL 2: ICX6610-QSFP 10-port 160G Module
UNIT 1: SL 3: ICX6610-8-port Dual Mode(SFP/SFP+) Module
800 MHz Power PC processor 8544E (version 0021/0023) 400 MHz bus
65536 KB flash memory
512 MB DRAM
STACKID 1 system uptime is 23 seconds
The system : started=cold start

........................
$
ICX Boot Code Version 7.3.02 (grz07302)
Enter 'a' to stop at memory test
Enter 'b' to stop at boot monitor
***** Interrupted by entering 'b' *****
BOOT INFO: load monitor from boot flash, cksum = 1fef
BOOT INFO: verify flash files....
Monitor>no password
OK! Skip password check when the system is up.
Monitor>reset
$
ICX Boot Code Version 7.3.02 (grz07302)
Enter 'a' to stop at memory test
Enter 'b' to stop at boot monitor
BOOT INFO: load monitor from boot flash, cksum = 1fef
BOOT INFO: verify flash files....
BOOT INFO: load image from primary copy...

platform type = 9
PCIE-1 LTSSM status: 22
PCIE Switch status: 0
......................
.....
Starting Main Task .Applying factory defaults..
INFO: startup config data is not available, try to read from backup
INFO: startup config data in the backup area is not available
..CPSS DxCh Version: cpss3.4p1 release
Pre Parsing Config Data ...
INFO: empty config data in the primary area, try to read from backup
INFO: empty config data in the backup area also

Parsing Config Data ...
INFO: empty config data in the primary area, try to read from backup
INFO: empty config data in the backup area also

FIPS_ENABLE bit was NOT set
Copyright (c) 1996-2012 Brocade Communications Systems, Inc. All rights reserv
ed.
UNIT 1: compiled on Apr 21 2014 at 03:12:44 labeled as FCXR07400f
(7221647 bytes) from Primary FCXR07400f.bin
SW: Version 07.4.00fT7f3
Boot-Monitor Image size = 370555, Version:07.3.02T7f5 (grz07302)
HW: Stackable ICX6610-48
UNIT 1: SL 1: ICX6610-48 48-port Management Module
Serial #: BXN2506H00A
License: ICX6610_PREM_ROUTER_SOFT_PACKAGE (LID: dzpHKFLjFFc)
P-ENGINE 0: type E02B, rev 01
P-ENGINE 1: type E02B, rev 01
UNIT 1: SL 2: ICX6610-QSFP 10-port 160G Module
UNIT 1: SL 3: ICX6610-8-port Dual Mode(SFP/SFP+) Module
800 MHz Power PC processor 8544E (version 0021/0023) 400 MHz bus
65536 KB flash memory
512 MB DRAM
STACKID 1 system uptime is 23 seconds
The system : started=warm start reloaded=by "reload"

........................

ICX6610-48 Router>
ICX6610-48 Router>ICX6610-48 Router>
Power supply 1 detected in standby mode.

Power supply 2 detected.
Power supply 2 is up.
Warning: Power Supply 1 Fan has failed in Unit 1

ICX6610-48 Router>en
No password has been assigned yet...
ICX6610-48 Router#erase startup-config
Erase startup-config failed or config empty.
dhcp server lease database is also removed
stacking flash file is also removed
ICX6610-48 Router#Warning: Power Supply 1 Fan has failed in Unit 1

ICX6610-48 Router#stack unconfigure me
This unit will recover pre-stacking startup config. Are you sure? (enter 'y' or
'n'): y
remove stack bootup flash
ICX6610-48 Router#reload
Are you sure? (enter 'y' or 'n'): y
Could not verify if the Running Config data has been changed.
Do you want to continue the reload anyway? (enter 'y' or 'n'): y
Halt and reboot
Rebooting(0)...
*
$
ICX Boot Code Version 7.3.02 (grz07302)
Enter 'a' to stop at memory test
Enter 'b' to stop at boot monitor
BOOT INFO: load monitor from boot flash, cksum = 1fef
BOOT INFO: verify flash files....
BOOT INFO: load image from primary copy...

platform type = 9
PCIE-1 LTSSM status: 22
PCIE Switch status: 0
......................
.....
Starting Main Task .Applying factory defaults..
INFO: startup config data is not available, try to read from backup
INFO: startup config data in the backup area is not available
..CPSS DxCh Version: cpss3.4p1 release
Pre Parsing Config Data ...
INFO: empty config data in the primary area, try to read from backup
INFO: empty config data in the backup area also

Parsing Config Data ...
INFO: empty config data in the primary area, try to read from backup
INFO: empty config data in the backup area also

FIPS_ENABLE bit was NOT set
Copyright (c) 1996-2012 Brocade Communications Systems, Inc. All rights reserv
ed.
UNIT 1: compiled on Apr 21 2014 at 03:12:44 labeled as FCXR07400f
(7221647 bytes) from Primary FCXR07400f.bin
SW: Version 07.4.00fT7f3
Boot-Monitor Image size = 370555, Version:07.3.02T7f5 (grz07302)
HW: Stackable ICX6610-48
UNIT 1: SL 1: ICX6610-48 48-port Management Module
Serial #: BXN2506H00A
License: ICX6610_PREM_ROUTER_SOFT_PACKAGE (LID: dzpHKFLjFFc)
P-ENGINE 0: type E02B, rev 01
P-ENGINE 1: type E02B, rev 01
UNIT 1: SL 2: ICX6610-QSFP 10-port 160G Module
UNIT 1: SL 3: ICX6610-8-port Dual Mode(SFP/SFP+) Module
800 MHz Power PC processor 8544E (version 0021/0023) 400 MHz bus
65536 KB flash memory
512 MB DRAM
STACKID 1 system uptime is 23 seconds
The system : started=warm start reloaded=by "reload"

........................

ICX6610-48 Router>
ICX6610-48 Router>ICX6610-48 Router>
Power supply 1 detected in standby mode.

Power supply 2 detected.
Power supply 2 is up.
Warning: Power Supply 1 Fan has failed in Unit 1

ICX6610-48 Router>
BOOT INFO: load monitor from boot flash, cksum = 1fef
BOOT INFO: verify flash files....
BOOT INFO: load image from primary copy...

platform type = 9
PCIE-1 LTSSM status: 22
PCIE Switch status: 0
......................
.....
Starting Main Task .Applying factory defaults..
INFO: startup config data is not available, try to read from backup
INFO: startup config data in the backup area is not available
..CPSS DxCh Version: cpss3.4p1 release
Pre Parsing Config Data ...
INFO: empty config data in the primary area, try to read from backup
INFO: empty config data in the backup area also

Parsing Config Data ...
INFO: empty config data in the primary area, try to read from backup
INFO: empty config data in the backup area also

FIPS_ENABLE bit was NOT set
Copyright (c) 1996-2012 Brocade Communications Systems, Inc. All rights reserv
ed.
UNIT 1: compiled on Apr 21 2014 at 03:12:44 labeled as FCXR07400f
(7221647 bytes) from Primary FCXR07400f.bin
SW: Version 07.4.00fT7f3
Boot-Monitor Image size = 370555, Version:07.3.02T7f5 (grz07302)
HW: Stackable ICX6610-48
UNIT 1: SL 1: ICX6610-48 48-port Management Module
Serial #: BXN2506H00A
License: ICX6610_PREM_ROUTER_SOFT_PACKAGE (LID: dzpHKFLjFFc)
P-ENGINE 0: type E02B, rev 01
P-ENGINE 1: type E02B, rev 01
UNIT 1: SL 2: ICX6610-QSFP 10-port 160G Module
UNIT 1: SL 3: ICX6610-8-port Dual Mode(SFP/SFP+) Module
800 MHz Power PC processor 8544E (version 0021/0023) 400 MHz bus
65536 KB flash memory
512 MB DRAM
STACKID 1 system uptime is 23 seconds
The system : started=cold start

........................

ICX6610-48 Router>
ICX6610-48 Router>
ICX6610-48 Router>ICX6610-48 Router>
Power supply 1 detected.

Power supply 2 detected.
Power supply 1 is up.
Power supply 2 is up.

ICX6610-48 Router>show version
Copyright (c) 1996-2012 Brocade Communications Systems, Inc. All rights reserv
ed.
UNIT 1: compiled on Apr 21 2014 at 03:12:44 labeled as FCXR07400f
(7221647 bytes) from Primary FCXR07400f.bin
SW: Version 07.4.00fT7f3
Boot-Monitor Image size = 370555, Version:07.3.02T7f5 (grz07302)
HW: Stackable ICX6610-48
UNIT 1: SL 1: ICX6610-48 48-port Management Module
Serial #: BXN2506H00A
License: ICX6610_PREM_ROUTER_SOFT_PACKAGE (LID: dzpHKFLjFFc)
P-ENGINE 0: type E02B, rev 01
P-ENGINE 1: type E02B, rev 01
UNIT 1: SL 2: ICX6610-QSFP 10-port 160G Module
UNIT 1: SL 3: ICX6610-8-port Dual Mode(SFP/SFP+) Module
800 MHz Power PC processor 8544E (version 0021/0023) 400 MHz bus
65536 KB flash memory
512 MB DRAM
STACKID 1 system uptime is 2 minutes 58 seconds
The system : started=cold start

ICX6610-48 Router> Please Click Here to Visit Our StoreSearchBy37 - 253301 | Loc: G22 | L: Mitchell |T: | PM: Nick | QTY: 0| Plan: L FREESHIP - 20LBS |21.00"x21.00"x5.00"30.00lbs |Start: $0.00 | BIN: $139.99 | |8/21/2023 ||51268
Buy Now

Documentation