The latest 3.8.2 replaces the original installer with the Kanotix installer. However, this installer does not seem to work properly. Any time when I launch it at the root prompt, it just freezes and nothing else happen. Any ideas?
Printable View
The latest 3.8.2 replaces the original installer with the Kanotix installer. However, this installer does not seem to work properly. Any time when I launch it at the root prompt, it just freezes and nothing else happen. Any ideas?
I dunno. Maybe don't launch it at the root prompt? Just last week I use the Kanotix installer to install 3.8.1 & did sudo knoppix-installer & it worked fine. I haven't yet tried 3.8.2.
Tks for your suggestion. I'll try again in the afternoon.
No. It doesn't work. :(
I've installed 3.8.1 on two Dell Latitude laptops by booting into the Konqueror intro from CD, using QTParted to set up a swap partition ( 512MB) and then an Ext3 partiton ( Min 4 GB ?) , committing the changes, then using the Knoppix Root shell to type sudo knoppix-installer . That worked fine for me both times . :D
My problem is the installer in 3.8.2 does not work. I don't have 3.8.1. My previous Knoppix is 3.7 which works fine.
... and if you enter kanotix-installer ??
No, I enter knoppix-installer. Well, kanotix-installer is a symlink to knoppix-installer. Does it matter?
Please help...