Printable View
I have no problem getting online when running Windows XP, but when I run the KNOPPIX DVD it will not connect.
The network card identifies as 3COM 3C900B TPO (generic) in Windows.
With Knoppix 4.0.2 on DVD I only get the loopback. Have used the netcardconfig to try to get a DHCP IP address but that fails.
Trying to set IP manually does not work either.
During loading of Knoppix I see the eth0.
Suggestions for a Linux newbie?
Thanks
use the comand: lspci -v
to see what hardware it is identifying
use the command: lsmod | sort
to get a list of loaded drivers. you hould see one entry as 3c90x
use the command: dmesg | grep -i eth
to see what drive & details if any it has loaded
use the command: ifconfig -a
to list all detected nework devices
Thanks,
lspci -v found my modem, 3Com network card and Matrox video card
lsmod | sort first item is 3c59x, further down the list is mii 3c59x
dmesg | grep -i eth no response
ifconfig -a eth0 lo sit0 all show errors:0
I do notice that when I run netcardconfig and do a DHCP broadcast, the light for the port on my linksys router goes out and then comes back on. Seems some activity is there.
Network Tools - Devices only shows loopback.
ping 192.168.1.1 to Linksys router fails
ifconfig eth0 up
returns:
SIOCSIFFLAGS: permission denied
Success!!
I am posting this message via Knoppix!
I never could get a DHCP but I started playing around with the various manual IP addressesin netcardconfig and got it to work.
This can be put in Wiki or something like that (I personaly can't do that, bad english, not enough knowledge)!Quote:
Originally Posted by Rik
I have plain ADSL modem, D-Link DSL-300T. Modem is setup as bridge, as my IP said to me. Every Linux distribution ask me for different setup, some can't connect at all. Network card can be setup, in general, in 3 ways - DHCP, static and "none". Than, you try and try and try.... Some distribution are smart enough to do by itself, other not. But, the most important thing is to know that there is a way to connect.
It was an interesting experience. I think getting the correct gateway and DNS IP's in the manual setup is what made the difference. I used another computer running XP to log into my Linksys router and got the needed IP's there.