Ok I've followed the process now what to do?

Hello all,

Tring to get my wireless going for my Acer Aspire 3000 it uses the broadcom internal wireless. Here's what I've done so far:

1) Used ndwrapper to load the driver it tells me driver accepted then to use the wlan config

2) Ran wlan config input my ESSID, WEP Channel ect all taken well

3) Run network card ap for wlan0 dchp discovery yes and it says is failed?

4) When I look at KWireless manager it show my card powered up it sees my network my wep my channnel but it says no access point available?

Any ideas as a side note xandros OCE works with my internal wireless card

-Eric