Need help with flat screen lcd monitor

This post is for Jorge......well I tried your suggestion:

knoppix vga=normal screen=1024x768 vsync=60 nosmc nodma

And it WORKED! :D

However, just before the final knoppix screen appears, there is a small distorted image that appears very briefly at top of screen. t looks like a squashed image of the picture of when you first boot knoppix from CD at that boot prompt. Then everythings OK. NOW I have gotten this far....how do I apply the code you gave me to my HDD install???? Do I have to edit LILO and put that code line in there somewhere? I am half way there! I have tried all the other suggestions from the other people but none of them worked. I will edit the code and take out maybe "NODMA" or the other one to see if it makes that distorted image go away. But its no big deal cause its finally working. Now I just need to get it to work on my hard drive install. Any further suggestions welcome... :lol:

I have noticed that my resolution is stuck at 640x480 no matter what I do! I included the code "screen=1024x768" in my bootup from CD. I know this monitor is capable of higher resolutions.
there is a little "configure display" icon at bottom of lower right screen but if I try to configure, it only has 640x480 as the only option! I think the code "vga=normal" must be the culprit. But I need to use this code in order for monitor to work. Are there other vga codes that might work?

Great!

You may not need the nosmc ot the nodma. nodma is for turning off hdd accereration. dma is set as default when you boot the KNOPPIX 3.4 liveCD and should work fine with new hdds. I used nosmc in KNOPPIX 3.3 because of a weird Dell BIOS quirk and I don't need it in 3.4.

To unstuck your 640x480 you have to find out what you video card make is and then use a cheatcode to modify what driver you use.

Good Luck,
AJG

Hi Jorge...OK I hear ya. Now As far as finding out what driver my video card uses....not sure about that. What would I have to do to find technical info on my video card? I know it is a 64 MB 3D card....its called a "MAD DOG"......So how do I use a cheat code to modify the driver? This is beyond my knowledge. If you could make a suggestion where to start I will attempt this next......I was wondering why when I finally did get the knoppix CD to boot yesterday why the info scrolling by on screen was bigger than i am used to seeing. Display is stuck at that one resolution and I thought something is up with the display. Please help further if you have time...thanks...bob58