post your output ofQuote:
Originally Posted by codegirl269
ifconfig
ifconfig -a
iwconfig
what led? do you have a router/gateway adsl? does it have DHCP enabled?
by leo
Printable View
post your output ofQuote:
Originally Posted by codegirl269
ifconfig
ifconfig -a
iwconfig
what led? do you have a router/gateway adsl? does it have DHCP enabled?
by leo
ehm... I meant BYEQuote:
Originally Posted by leonardo4it
:roll:
Hi,
My wireless card has two leds, one for power and one for link. I have a wireless router that I am using to access the net with a cable modem and have no idea if DHCP is enabled. Here is my output:
ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:18 errors:0 dropped:0 overruns:0 frame:0
TX packets:18 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:900 (900.0 b) TX bytes:900 (900.0 b)
ifconfig -a
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:18 errors:0 dropped:0 overruns:0 frame:0
TX packets:18 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:900 (900.0 b) TX bytes:900 (900.0 b)
wlan0 Link encap:Ethernet HWaddr 00:0C:E5:4E:9A:B4
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:65 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:15974 (15.5 KiB) TX bytes:0 (0.0 b)
Memory:c400000-c401fff
iwconfig
lo no wireless extensions.
wlan0 IEEE 802.11g ESSID:"mynetwork"
Mode:Managed Frequency:2.437 GHz Access Point: 00:0D:3A:72:0D:8F
Bit Rate:54 Mb/s Tx-Power:25 dBm
RTS thr:2347 B Fragment thr:2346 B
Encryption key:1234-5678-1234-5678-1234-5678-12 Security mode:restricted
Power Management:off
Link Quality:100/100 Signal level:-42 dBm Noise level:-256 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0