Sagem F@st 800 ADSL modem....

[DanBallance]

hi there, i am new to knoppix (and linux in general) and am enjoying learning about the OS.

However, i can't seem to get my modem (sagem f@st 800 ADSL) to work with knoppix. i note there is a driver on the sagem site for redhat, mandrake and suse.

of these, i was considering switching to the BLAG (brixton linux action group) breed of redhat.... BUT i then noted that it will not read my existing NTFS partitions, which Knoppix, quite brilliantly does

so my question to you all is this: will the sagem modem ever be supported under knoppix...? i dont really have any money for a couple of months to buy any new kit

keen to learn more, but need access to the net to do so !

dan

[user unknown]

In general, there are no special drivers for redhat, suse, or mandrake.

In detail, there might be an installation-packet for one of these distros.
Since knoppix is based on debian, look for a .dep - Package.
Redhat uses rpm, and you might try the rpm, if there is no .dep.
Try rpm-> to see, if there is rpm installed.
(-> stands for tab, to test tab-expansion)

I don't know what kind of package-management suse and mandrake use.

Perhaps there is a raw source -tar.bz2 or -tar.bz - package, which could be used.
Try to get this, if you don't have rpm, or it doesn't work.

Pay attention of the kernel is a much more serious question, (>= 2.6.0 or not) since the module-architekture changed with 2.6
uname -r tells you your kernel version.

[DanBallance]

cheers for that, i'm follwoing up your suggestions now, nive one