Hi,
I've been surfing here for a while and I found this post:
http://www.knoppix.net/forum/viewtop...804&highlight=

Of course, to make it easier here are the instructions that should work to setup a wireless lan card in Knoppix:
1. Go to the command line and type... wlcardconfig
2. Enter your wireless network's name (SSID) when prompted.
3. Enter your WEP key/password (if your network is encrypted) when prompted.
4. Leave the other specs blank.
5. After you complete the config, at the command line type... pump -i eth0
(where "0" is the number of your wireless card)
Thanks tony-c and others!

Esher2292