Hi,

I'm having problem with my KNOPPIX(newest ver 3.4) installation on the HDD.
I first tried to install on the windows me hard-disk and i got to live and started to install but it said at the beginning OPENED DISK READ-ONLY - YOU HAVE NO PERMISSION TO WRITE. Well i cleaned the whole hard-disk and now there is nuthing on the hard-disk, but now i get also No DOS Partition to create swap file error.

Then i tried to install to my second hard-disk(i put the cables in places and started the computer). Second hard-disk had red hat in it. I got again in knoppix live and started to install...the install was going just fine and i got to configure install and started it, but then it said alot of error messages. Next i formatted the whole hard-disk AGAIN, but it didn't help.

I have now tried to create partitions of linux and linux swap. I also have tried to add third partition with fat12/16/32 file system, but nuthing has helped. I have also tried to create dos partition with my dos boot disks, but it doesnt help.

So what am i doing wrong?

So now i have no file systems in my two hard-disks and none of those work. I have tried to run "sudo knoppix-installer", but it says always "OPENED DISK READ-ONLY - YOU HAVE NO PERMISSION TO WRITE".

I thought that i had permission to install to hard-disk if i clean the whole system and start from the clean system, but no i can't install .

My computer is PENTIUM 2 266MHZ AND IT HAS 64MB SDRAM.

ps. now i can't even get to graphical interface of the knoppix, so i need to use command line