-
Senior Member
registered user
Your /etc/network/interfaces should look something like this:
auto lo
iface lo inet loopback
auto eth0
iface eth0 inet dhcp
OR you can set a static I.P. and use gateway which refer to your router i.p. Then your /etc/network/interfaces should look something like this:
auto lo eth0
iface lo inet loopback
auto lo eth0
iface eth0 inet static
address 192.168.x.x
netmask 255.255.255.0
network 192.168.x.0
broadcast 192.168.x.255
gateway 192.168.x.x (what was set on your router)
You /etc/resolve.conf is wrong. The nameserver must be something that provided by your isp.
Usually ISP will give you two DNS IP. You can check using your Windows by running comannd : nslookup or ipconfig.
Similar Threads
-
By dundas in forum Networking
Replies: 3
Last Post: 09-06-2010, 11:46 AM
-
By frenco in forum Networking
Replies: 2
Last Post: 05-29-2005, 08:58 AM
-
By k225yt in forum Networking
Replies: 2
Last Post: 03-25-2005, 12:56 PM
-
By ForbiddenSword in forum General Support
Replies: 7
Last Post: 07-31-2004, 05:26 AM
-
By master_b in forum Networking
Replies: 3
Last Post: 05-14-2004, 04:31 AM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules

🔀 Juniper Networks EX2300-C-12P 12× Gigabit PoE+ • 2× 10G SFP+ Compact Switch ⚡
$109.99

Juniper EX2300 12-Port Gigabit PoE+ Managed Network Switch P/N: EX2300-C-12P
$149.99

Juniper Networks EX3400-24T 24-Port Ethernet Switch w/Power Cord
$174.99

Juniper EX3400-24P 24-Port PoE+ GbE + 4-Port 1/10Gb SFP Switch
$245.00

JUNIPER QFX5120-48Y-AFO 48x 10/25GbE SFP28 8x 40/100GbE Network Switch Dual PSU
$6998.00

Juniper MX204 +JUNOS and Dual Power Supply
$7299.99

Juniper Networks AP33-US Indoor Wifi6 (US Version) 5GHz: 4x4:4; 2.99
$24.99

Juniper Networks QFX-SFP-DAC-7MA to Brocade (Formerly) XBR-TWX-0701 Comp TAA
$196.99

Juniper Networks Mist Wireless Access Points, Model AP45
$59.99

Juniper Networks EX2300-48P 48-Port Gigabit PoE Managed Ethernet Switch
$79.99