Hi all,

I try to run Knoppix 3.4 on my PC (AMD Athlon 800 MHz, 384 MB RAM, ATI 3D Rage IIC AGP, see lspci -i below).

Everything seems to run fine until start of X11. I see the yellow KDE background, but then the system freezes I have to turn off my PC then. I have tried nearly all boot cheatcodes (failsafe, different screen resolutions, nodma, xserver=XF86_SVGA etc.), the system always hangs....

Booting into runlevel 2 (textmode) works ok.

So the problem seems to be the X configuration. Running X (KDE) with SUSE Linux on the same PC works....

Any ideas ? Thanks in advance ....

Hans-Peter


00:00.0 Host bridge: VIA Technologies, Inc. VT8363/8365 [KT133/KM133] (rev 02)
Flags: bus master, medium devsel, latency 0
Memory at d0000000 (32-bit, prefetchable) [size=64M]
Capabilities: [a0] AGP version 2.0
Capabilities: [c0] Power Management version 2

00:01.0 PCI bridge: VIA Technologies, Inc.: Unknown device 0583 (prog-if 00 [Normal decode])
Flags: bus master, 66Mhz, medium devsel, latency 0
Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
I/O behind bridge: 0000c000-0000cfff
Memory behind bridge: d4000000-d5ffffff
Prefetchable memory behind bridge: d6000000-d6ffffff
Capabilities: [80] Power Management version 2

00:07.0 ISA bridge: VIA Technologies, Inc. VT82C686 [Apollo Super South] (rev 22)
Subsystem: VIA Technologies, Inc. VT82C686/A PCI to ISA Bridge
Flags: bus master, stepping, medium devsel, latency 0

00:07.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT8233/A/C/VT8235 PIPC Bus Master IDE (rev 10) (prog-if 8a [Master SecP PriP])
Subsystem: VIA Technologies, Inc. VT82C586/B/VT82C686/A/B/VT8233/A/C/VT8235 PIPC Bus Master IDE
Flags: bus master, medium devsel, latency 32
I/O ports at d000 [size=16]
Capabilities: [c0] Power Management version 2

00:07.2 USB Controller: VIA Technologies, Inc. USB (rev 10) (prog-if 00 [UHCI])
Subsystem: VIA Technologies, Inc. (Wrong ID) USB Controller
Flags: bus master, medium devsel, latency 32, IRQ 5
I/O ports at d400 [size=32]
Capabilities: [80] Power Management version 2

00:07.3 USB Controller: VIA Technologies, Inc. USB (rev 10) (prog-if 00 [UHCI])
Subsystem: VIA Technologies, Inc. (Wrong ID) USB Controller
Flags: bus master, medium devsel, latency 32, IRQ 5
I/O ports at d800 [size=32]
Capabilities: [80] Power Management version 2

00:07.4 Host bridge: VIA Technologies, Inc. VT82C686 [Apollo Super ACPI] (rev 30)
Flags: medium devsel, IRQ 9
Capabilities: [68] Power Management version 2

00:0a.0 Multimedia audio controller: Fortemedia, Inc Xwave QS3000A [FM801] (rev a0)
Subsystem: Fortemedia, Inc: Unknown device 1319
Flags: bus master, medium devsel, latency 32, IRQ 5
I/O ports at e800 [size=128]
Capabilities: [dc] Power Management version 1

00:0a.1 Input device controller: Fortemedia, Inc Xwave QS3000A [FM801] (rev a0)
Subsystem: Fortemedia, Inc: Unknown device 1319
Flags: bus master, medium devsel, latency 32, IRQ 11
Capabilities: [dc] Power Management version 1

01:00.0 VGA compatible controller: ATI Technologies Inc 3D Rage IIC AGP (rev 7a) (prog-if 00 [VGA])
Subsystem: ATI Technologies Inc: Unknown device 0084
Flags: bus master, stepping, medium devsel, latency 32, IRQ 11
Memory at d6000000 (32-bit, prefetchable) [size=16M]
I/O ports at c000 [size=256]
Memory at d5000000 (32-bit, non-prefetchable) [size=4K]
Expansion ROM at <unassigned> [disabled] [size=128K]
Capabilities: [5c] Power Management version 1