wanting to make a install to hard drive after formatting. 128 mb of ram and 30 gig hardrive. this enough to run knoppix.
thanks pete
wanting to make a install to hard drive after formatting. 128 mb of ram and 30 gig hardrive. this enough to run knoppix.
thanks pete
Pete,
Sounds good to me, only you might need a swap partition...
From what I know of Knoppix, your swap should be in the following calculation:
1 GB - total memory = SWAP partition
or
500 MB
( which ever is greater )
If, on the other hand, you had 1 GB of RAM, then you would not need a swap at all.
You might check the DOCS link at the top of the page, and find the "minimum requirements" FAQ ( frequently asked questions ) and see how you compare, but, I think you are ok on them, not sure on your processor though, you didn't provide that in your initial post...
Hope this helps,
Ms. Cuddles

OWC Mercury Elite Pro 2 Bay RAID Enclosure with USB 3.2 for Dual 3.5 inch HDDs
$87.99
Glyph StudioRAID 28TB External RAID Hard Drive Thunderbolt 2 USB 3.0 7200RPM
$300.00
Broadcom 9600-24i Tri-Mode RAID Controller 4.0 NVMe SAS SATA NEW 05-50111-01003
$639.69
Intel VROC Premium RAID Controller Card PCIe Add-On Module VROCPREMMOD
$265.00
WAVLINK RAID 2 Bay Hard Drive Docking Station SATA 2.5/3.5'' SSD HDD Enclosure
$119.99
2-Bay/4-Bay Hard Drive Enclosure for 3.5"/2.5'' SATA HDD/SSD 10Gbps USB-C 3.2
$119.99
Dell PowerEdge HBA330 LP PCI-E 12GBs RAID SAS Controller Adapter J7TNV
$18.95
Acasis USB 3.2 2 Bay HDD RAID Enclosure for 2.5/3.5" SATA Drives External Array
$55.00
Intel® Integrated RAID Mezzanine Module RMS3HC080 SAS/SATA H24093-204
$24.97
Adaptec ASR-71605 16-Port 1Gbps PCIe RAID Card High Profile
$18.49