wanting to make a install to hard drive after formatting. 128 mb of ram and 30 gig hardrive. this enough to run knoppix.
thanks pete
wanting to make a install to hard drive after formatting. 128 mb of ram and 30 gig hardrive. this enough to run knoppix.
thanks pete
Pete,
Sounds good to me, only you might need a swap partition...
From what I know of Knoppix, your swap should be in the following calculation:
1 GB - total memory = SWAP partition
or
500 MB
( which ever is greater )
If, on the other hand, you had 1 GB of RAM, then you would not need a swap at all.
You might check the DOCS link at the top of the page, and find the "minimum requirements" FAQ ( frequently asked questions ) and see how you compare, but, I think you are ok on them, not sure on your processor though, you didn't provide that in your initial post...
Hope this helps,
Ms. Cuddles

VINTAGE DEC LA34/ LA100 SERIES KEYBOARD W/NUMERIC PAD 70-17864-01C
$140.00
Vintage DEC Digital Starion 200 Desktop PC Powers On Boots To BIOS NO HDD - DW
$269.99
Vintage DEC Digital DECtalk III DTC03 70-22667-01 Chassis Parts Repair
$269.00
Vintage Digital DEC 54-15688 rainbow color graphics option
$129.99
Vintage DEC LK201 Computer Keyboard Used
$59.97
Vintage DEC PDT11 (VT100 Series) Terminal (Powers On).
$550.99
lot of 2 ~ Vintage Digital DEC ~ H8584-AA ~ 8-pin MP to 6-pin MJ **NOS**
$18.99
6 Vintage DEC Digital System Building Blocks - Flip Chips
$295.00
Vintage DEC/Mostek memory systems MK 8015 AA-00 6805-08015 1100 REV C(B7)
$279.99
Vintage DEC Digital VR319-DA 19" High Resolution Monochrome CRT Monitor - Tested
$180.00