After having done a harddisk install of Knoppix 3.6 I find that the system gets confused over my network card. I think it is due to the fact that I have a Firewire card in which it thinks is also a network card. Hence instead of justing staring eth0 it also starts eth1. The interesting thing is that they are not always asigned to the same card...

Hence I have to do a:

ifconfig -a

to find out where the ethernet card really is, then do a:

ifdown eth0 eth1

to stop both, and then do a:

ifup eth0 or eth1 depending on where the ethernet really is...

Strange. How can I prevent this from happening? For your information I include the results of ifconfig -a:

eth0 Link encap:Ethernet HWaddr 00:C0:A8:8D:2A:76
inet addr:62.204.207.16 Bcast:62.204.207.16 Mask:255.255.255.128
inet6 addr: fe80::2c0:a8ff:fe8d:2a76/64 Scope:Link
IPX/Ethernet 802.2 addr:922333C3:00C0A88D2A76
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:39564 errors:0 dropped:0 overruns:0 frame:0
TX packets:15115 errors:0 dropped:0 overruns:0 carrier:0
collisions:4633 txqueuelen:1000
RX bytes:18989122 (18.1 MiB) TX bytes:3603145 (3.4 MiB)
Interrupt:21 Base address:0x9c00

eth1 Link encap:UNSPEC HWaddr 00-30-BD-0B-00-00-15-C8-00-00-00-00-00-00-00-00
inet addr:62.204.207.16 Bcast:62.204.207.16 Mask:255.255.255.128
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:55 errors:1 dropped:1 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:3492 (3.4 KiB)

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:26254 errors:0 dropped:0 overruns:0 frame:0
TX packets:26254 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:4061191 (3.8 MiB) TX bytes:4061191 (3.8 MiB)

sit0 Link encap:IPv6-in-IPv4
NOARP MTU:1480 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)


Thanks,

Tim