You need to reinstall and this time don't use IGNORE_CHECK=1.
![]()
![]()
Greetings,
I am very new to linux and recently installed the Knoppix 3.6 CD on a PC with success. So, I decided to install it on my laptop (HP Pavilion without a floppy drive) using the installer that comes with it. I used the IGNORE_CHECK=1 sudo knoppix-installer and when through the installation as I did with the PC. I chose the basic configuration and partitioned the whole hard drive for a single linux boot. Everything appeared to go well until it was time to remove the CD and reboot. I get the usual HP logo page and then I receive the following:
Hard disk boot sector invalid
Press 'H' to retry Hard Disk, any other key for floppy
Again, I don't have a floppy and selected "No" when it was offered during the installation.
What has happened and how do I get beyond this issue?
Thanks,
NEOMinds
You need to reinstall and this time don't use IGNORE_CHECK=1.
![]()
![]()

Kingston 32GB 64GB 128GB 256GB USB 3.0 Flash Drive Thumb Memory Stick Pen lot
$285.90
Micro SD Adapter To SD HC SDHC Memory Card Adapter Reader NEW
$1.39
SK Hynix 8GB 1RX4 PC4-2133P-RC0-10 Registered Server RAM HMA41GR7MFR4N-TF TD AB
$34.99
TF/SD Card Adapter Camera Reader Android Type-c For iPhone17 Pro Max Plusm lot
$573.98
USB 3.0 Flash Drive 32GB 64GB 128GB Memory Stick Thumb Stick Lot Pack
$826.09
A-Tech 8GB DDR3 1600 PC3-12800 Laptop SODIMM 204-Pin Memory RAM PC3L DDR3L 1x 8G
$21.68
NEW Lenovo Samsung 64GB LPDDR5X 8533 MHz LPCAMM2 Memory,For ThinkPad P1 Gen7,8,9
$1349.00
SK Hynix 16GB DDR4 2133MHz PC4-17000P-R 288-Pin ECC RDIMM, HMA42GR7MFR4N-TF
$55.00
Samsung 32GBX2 1Rx4 PC4-3200AA DDR4 ECC Server Memory M393A4G40AB3-CWEBQ 64GB EC
$370.00
SMART(Micron)SafeStor 32GB(1X32GB) 1RX4 NN4-3200AA(DDR4) HPE Server Memory
$159.98