I have read most articles on these pages regarding connection problems, but still have no connection.

Below is a copy of the output for ipconfig /all:

Windows IP Configuration
Host Name: Les-tab816t etc.
Primary Dns Suffix:
Node Type: Unknown
IP Routing Enabled: No
WINS Proxy Enabled: No

Ethernet adapter Local Area Connection:
Media State: Media disconnected
Description: Realtek RTL8139/ etc.
Physical Address: 00-50-70 eetc.

Ethernet adapter Local Area Connection 2:

Description: Intel <R> PRO/1000 CT Desktop connection
Physical address: 00-50-70 etc
Dhcp Enabled: Yes
Autoconfig enabled: Yes
IP Address: 10.0.0.8
Subnet Mask: 255.0.0.0
Default Gateway: 10.0.0.2
DHCP Server: 10.0.0.2
DNS Server: 10.0.0.2
Lease obtained: 6/12/2004 03:35
Lease expires: 7/12/2004 03:35

PPP adapter Cozahost (the name of my ISP):

Connection specific DNS suffix:
Description: WAN <PPP/SLIP> Interface
Physical address: 00-53-45 etc.
Dhcp enabled: No
IP Address: 165.146. etc.
Subnet Mask: 255.255. etc.
Default gateway: 165.146. etc.
DNS servers: 196.25.255.34
196.25.255.3

When in Knoppix, I have run the ADSL/PPPOE config wizard. The results are:

I have found 2 ethernet devices:
eth0, eth1

then:

I found access concentrator on eht0. Set up PPOE on eth0?

I choose 'Yes' all the way through.

I have tried the netcardconfig in the shell, but am unsure of some of the settings:

I am asked for the following:
select network device: eht0, eth1 (which do I choose?)
IP Address (I assume this is the IP Address listed above under PPP adapter)
Network mask: (is this the subnet mask on the above print out?)
Broadcast: (no idea what to put here)
Default gateway (again, I suppose that's the one from PPP above)
Name server: (this has me truly stumped).

Can anyone advise?

Thanks,

Bill