I'm using the Knoppix 3.7 20041208 live CD. When booting, it outputs messages that show it does see a Firewire device, but when I do fdisk -l all I see is /dev/hda and my partitions therein.

Here's the lspci -vv for the firewire device:

02:07.0 FireWire (IEEE 1394): Texas Instruments TSB43AB22/A IEEE-1394a-2000 Controller (PHY/Link) (prog-if 10 [OHCI])
Subsystem: Toshiba America Info Systems: Unknown device 0001
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (500ns min, 1000ns max)
Interrupt: pin A routed to IRQ 10
Region 0: [virtual] Memory at 20000800 (32-bit, non-prefetchable) [size=2K]
Region 1: [virtual] Memory at 20004000 (32-bit, non-prefetchable) [size=16K]
Capabilities: [44] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=55mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-

I'm told modprobe pcilynx will do the trick, but that doesn't work with the 20041208 Knoppix CD. Any ideas?

My whole reason for using Knoppix is to run partimage and backup the machine to my 80GB Firewire drive.

Thanks,

Ed