I have a knoppix 3.4 HD install, and I had some time ago swapped nic's between the knoppix box and the freesco router box. I didn't realize then that knoppix HD doesn't check for change in hardware like my RH 6.1 does.

The box was loading the old module, from the kernel-specific-module file. Before finding this, I had searched all the many module loading files, and tried configuring there, if they didn't have an eth0 entry, I added one. Perhaps this may have interfered somewhere, after I found the module. I did find the card Identified correctly in one file, though; lspci -v showed the card correctly too.

Is there a setup program on the HD install that can be used to correct this? Or if not, what files do I need to edit to see that it gets it's dhcp?