Knoppix 3.8 network card config locks up system

**rgruhn** · 03-31-2005, 02:33 PM

I am using Knoppix 3.6. and 3.7 without any network problems with always the same standard hardware (= Intel network card).
Now: Booting Knoppix 3.8 stops at eth0, DHCP broadcast - nothing is going on. There is a DSL router with DHCP server.
Finally I found the parameter [nodhcp] and used it, but after starting Knoppix I cannot install the network card by hand. The system freezes totally after the input of the correct static IP addresses.