How do I pass arguments to a scsi driver?

[Dave_Bechtel]

--Try (as root, WITH the single quotes)
" modprobe aha152x 'your-options-here' "

(From /usr/src/linux/drivers/scsi/README.aha152x)

CONFIGURATION ARGUMENTS:

IOPORT base io address (0x340/0x140)
IRQ interrupt level (9-12; default 11)
SCSI_ID scsi id of controller (0-7; default 7)
RECONNECT allow targets to disconnect from the bus (0/1; default 1 [on])
PARITY enable parity checking (0/1; default 1 [on])
SYNCHRONOUS enable synchronous transfers (0/1; default 1 [on])
DELAY: bus reset delay (default 100)
EXT_TRANS: enable extended translation (0/1: default 0 [off])

2. specify only what you need to (irq or io is required; new)

io=IOPORT0[,IOPORT1]
IOPORT for first and second controller

irq=IRQ0[,IRQ1]
IRQ for first and second controller

scsiid=SCSIID0[,SCSIID1]
SCSIID for first and second controller

reconnect=RECONNECT0[,RECONNECT1]
allow targets to disconnect for first and second controller

parity=PAR0[PAR1]
use parity for first and second controller

sync=SYNCHRONOUS0[,SYNCHRONOUS1]
enable synchronous transfers for first and second controller

delay=DELAY0[,DELAY1]
reset DELAY for first and second controller

exttrans=EXTTRANS0[,EXTTRANS1]
enable extended translation for first and second controller


If you use both alternatives the first will be taken.

I'm trying to boot knoppix on an old computer that has a scsi cdrom. I know the driver I need and the arguments to pass to it because the driver doesn't detect it. I use the aha152x driver and need to pass the arguments: 0x340,11,0,1. Can anyone tell me how to do that? Thanks.