Computer hangs on "DHCP Broadcasting for IP"

[rwcitek]

using 'pump -i eth1' seemed to do the trick after following your instructions.

So to summarize, if you have a "Ethernet controller: Digital Equipment Corporation DECchip 21142/43 (rev 30)" card and the de4x5 module is loaded, then to enable networking you must do the following:

rmmod de4x5
modprobe tulip
pump -k
pump -i eth0

Of course, change eth0 to your actual interface.

Regards,
- Robert
http://www.cwelug.org/

[NotEmul8d]

yessir, that works for me. perhaps it'll work for the other fellow, too..