Recover Files from NTFS

**stevelw** · 07-08-2005, 03:18 PM

Unfortunately, Knoppix reports that it cannot open the device on an fdisk either. I suspect the stick is well and truly shot.

**foamrotreturns** · 07-08-2005, 08:30 PM

Originally Posted by stevelw

Unfortunately, Knoppix reports that it cannot open the device on an fdisk either. I suspect the stick is well and truly shot.

This is very uncommon and I would be surprised if it's actually kaput. What's the manufacturer?

**stevelw** · 07-09-2005, 05:36 PM

No idea I'm afraid. It's a 512Mb unit that was given away by Borland to delegates at a recent product presentation in Manchester. The only label on it is the name 'BORLAND'

**foamrotreturns** · 07-09-2005, 06:15 PM

Originally Posted by stevelw

No idea I'm afraid. It's a 512Mb unit that was given away by Borland to delegates at a recent product presentation in Manchester. The only label on it is the name 'BORLAND'

Well if you think it's shot, there can't be any harm in performing a low-level format, right?
do this:
dd if=/dev/zero of=/dev/sda1 (replace sda1 with whatever device it is)

**stevelw** · 07-10-2005, 11:43 AM

That worked fine. Did a low-level format (in KNoppix) and then a standard format as FAT in XP. However, after remounting on KNoppix and settings device to be writeable, still caoont copy files from NTFS to the device. Generates message ...

Could not write to /mnt/sdf1/<filename>

**stevelw** · 07-10-2005, 12:08 PM

Forget last post. Tried again and it worked fine!

Thanks for the assist.

**Capt. Cautious** · 07-16-2005, 04:57 PM

Welcome to the forum. I had not realized that there was a simpler way to change the rw status of a flashdrive. What I usualy do is change mount the flash drive from root. You have to remember though to unmonut it from root also. the cmd I use goes like this in Knoppix 3.8,9 .. first you right click and mount the flashdrive then (use the expression withut the quotes.
" mount -o remount,rw /dev/sdf1" or possibly "mount -o remount,rw /mnt/sdf1" then you can write to it or drag and drop. I hope this helps. the unmount would read something like " umount /dev or mnt/sdf1" I too am new to this forum and wish you happy learning.
Captain Cautious