Results 1 to 7 of 7

Thread: USB-Speed slows down with 3.9

  1. #1
    Junior Member
    Join Date
    Jul 2005
    Posts
    4

    USB-Speed slows down with 3.9

    Hi,

    i use Knoppix 3.9 and an external Fujitsu 2,5" HD 40GB in an USB-Case.

    I want to use partimage to make an uncompressed disk image and want to save the image on the external HD. Storing starts with round about 50MB/m and slows down to 10MB/m within 5 minutes.

    What could be the reason therefor?

    cu, Frakes

  2. #2
    Junior Member
    Join Date
    Jul 2005
    Posts
    3
    care if you have:
    not a frontpanel connector with unshielded cable to the mainboard - use the usb ports on the back directly on the mainboard
    use a shielded usb2 cable for outside the computer - never use a wire with some plastic on it as many cheap cardreaders!
    if this still doesnt work, try out another pc, maybe your controller is defective, socket .. damaged
    touch the computer first, then plug in usb device (static discharge)
    good luck

  3. #3
    Junior Member
    Join Date
    Jul 2005
    Posts
    4
    Hi,

    i use the usb-ports on the motherboard with a standard usb-cable. I tried another PC to write back the image and it was the same, first 60MB/min then it slows down to 15MB/min.

    The case, the HD and the cable are OK, i tried them on the same PC's under W2K-Professional and it works fast. It has to be an error on the combination external HD and Knoppix.

    cu, Frakes

  4. #4
    Junior Member
    Join Date
    Jul 2005
    Posts
    3
    i reached ~18MB/s (i used a clock for measuring time) with knoppix 3.7 2004-08-16 (cheatcode ... usb2)
    ill hav a try on win2000 for to see the max. of my usb-hdd -
    usb2 max would be ~40MB/s - a usb2.0-hdd reaches far below

    v3.9 wont reach more than ~3MB/s !?!
    do you use any cheatcodes?

    on my ancient pc166 usb1.1 only 0.5MB/s no matter which knoppix


  5. #5
    Junior Member
    Join Date
    Jul 2005
    Posts
    4
    Hi,

    i'll check it out the day after tomorrow. i'm meanwhile unsure about my average performance with w2kprof.

    There were to many numbers after 10 hours of work.


    cu, Frakes

  6. #6
    Junior Member
    Join Date
    Jul 2005
    Posts
    3
    i couted the seconds and the maximum write speed
    with my chiligreen usb2.0-hdd with a seagate80GB inside on winXP is:

    14 MB/s

    even worse

  7. #7
    Junior Member
    Join Date
    Jul 2005
    Posts
    4
    Hi,

    it's a problem of Knoppix.

    I didn't check the average performance, but i took a try with the SystemRescueCD on the same configuration.

    It tooks 75 minutes to write compressed 1,5GB to the USB-HD and it take 35 minutes to write the image back on a PC.

    It may be a problem with the external USB-HD, or a problem of reading and writing NTFS under Knoppix, or something else.

    However, i have to compensate the lost time and can't have a closer look on the problem, i'll check it, if anything runs.

    cu, Frakes

Similar Threads

  1. USB flash drive slows to 10% of normal speed when HD reads
    By cvevans in forum Hardware & Booting
    Replies: 0
    Last Post: 04-21-2007, 02:43 AM
  2. Can't get usb 2.0 at high speed only full speed
    By play1962 in forum Hardware & Booting
    Replies: 5
    Last Post: 05-09-2006, 06:14 PM
  3. Knoppix boots, but slows down a lot
    By javiergarza4 in forum General Support
    Replies: 12
    Last Post: 03-06-2004, 09:23 AM
  4. CD/DVD Drive Reading Speed vs. CPU Speed
    By migasf in forum General Support
    Replies: 1
    Last Post: 11-26-2003, 07:18 PM
  5. Themes Manager Slows Down HD Install/Bug?
    By bongski55 in forum Hdd Install / Debian / Apt
    Replies: 7
    Last Post: 06-12-2003, 02:35 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


🔀 Juniper Networks EX2300-C-12P 12× Gigabit PoE+ • 2× 10G SFP+ Compact Switch ⚡ picture

🔀 Juniper Networks EX2300-C-12P 12× Gigabit PoE+ • 2× 10G SFP+ Compact Switch ⚡

$119.00



Juniper EX2300 12-Port Gigabit PoE+ Managed Network Switch P/N: EX2300-C-12P picture

Juniper EX2300 12-Port Gigabit PoE+ Managed Network Switch P/N: EX2300-C-12P

$149.99



JUNIPER NETWORKS MIST AI AP63-US HIGH PERFORMANCE OUTDOOR ACCESS POINT - WHITE picture

JUNIPER NETWORKS MIST AI AP63-US HIGH PERFORMANCE OUTDOOR ACCESS POINT - WHITE

$59.99



Juniper Networks EX2300-48P 48-Port Gigabit PoE Managed Ethernet Switch picture

Juniper Networks EX2300-48P 48-Port Gigabit PoE Managed Ethernet Switch

$79.99



Juniper SRX320 8-Port Security Services Gateway Appliance w/ AC Adapter picture

Juniper SRX320 8-Port Security Services Gateway Appliance w/ AC Adapter

$59.99



Juniper Networks EX2300 (EX2300-48P) 48 Ports Ethernet Switch picture

Juniper Networks EX2300 (EX2300-48P) 48 Ports Ethernet Switch

$249.99



Juniper EX2300-C-12P POE+ Switch 12 x 1GbE & 2 SFP+ 10G uplinks picture

Juniper EX2300-C-12P POE+ Switch 12 x 1GbE & 2 SFP+ 10G uplinks

$124.99



Juniper EX2300-48P 48-Port SFP PoE+ Managed Gigabit Ethernet Network Switch picture

Juniper EX2300-48P 48-Port SFP PoE+ Managed Gigabit Ethernet Network Switch

$64.99



Juniper QFX5100-48S-3AFI 48-Port SFP+ 6 QSFP+ 2x SFP/RJ-45 Management picture

Juniper QFX5100-48S-3AFI 48-Port SFP+ 6 QSFP+ 2x SFP/RJ-45 Management

$249.97



Juniper QFX5100-24Q-3AFo 24x QSFP+ Ports Dual MGMT 2x AC Power QFX5100-24Q-AFo picture

Juniper QFX5100-24Q-3AFo 24x QSFP+ Ports Dual MGMT 2x AC Power QFX5100-24Q-AFo

$586.63