to: Allowee
re: hdd install

OK, after booting with all your special settings on (from boot: screen with knopppix commands) click the K in the bottom left corner of the desktop.

Make sure you have a linux formatted disk in the floppy drive (boot disk is ok).

Then click KNOPPIX and then clickk Save KNOPPIX Config.

This creates a knoppix.sh bash file and saves it on the floppy saving your desired settings.

To boot up again with those settings without having to type them every time on the boot: screen, make sure that same disk is in the floppy drive and just type at the boot: knoppix floppyconfig.

That should do it!

Good Luck,