eth0 not working after 'fixing' loopback

[ibrewale]

I have knoppix 3.9 installed and had some problems with lo configuring. I was able to fix per the documented bug here:
http://www.knoppix.net/wiki/Bugs/3.9-2005-05-27 (#15)

After rebooting if I perform ifconfig -a, my loopback is set up as it should 127.0.0.1, but now I cannot connect to my DSL.

In the past, I always had to type in pump -i eth0
and my connection to the internet would work.

Now I get a "failed operation" when I do that. I have also tried ifup eth0, and it reports back that it is an 'unknown' device.

Im lost as to what to do now, to get eth0 configured so that I can use my DSL.

Any pointers?

Thanks

Jerry

[ibrewale]

Well, I rebooted several times, and for some reason I was able to use

pump -i eth1

and it worked.

eth0 did not work, I tried to ifconfig eth0 down, and then up again.

Not sure how to have eth1 configured on startup without doing pump.

Thanks

Jerry

[UnderScore]

So you have 2 ethernet devices? Have you inspected/changed the /etcnetwirk/interfaces file at all?

[ibrewale]

I only have 1 ethernet device (network card), I didn't know what to change, to just show 1.

I did take your cue and look into /etc/network/interfaces file, and this is what I have:

# /etc/network/interfaces -- configuration file for ifup(8), ifdown(8)

# The loopback interface
# automatically added when upgrading
auto lo
iface lo inet loopback

Where else could I look to see about fixing this so I only have the 1 ethernet device?

Thanks for your help again UnderScore!


Jerry