Sounds like it takes a while to get your video card detected and drivers for it loaded. Vanta is Nvidia right and I assume that it IS in fact an AGP card? You could boot like this:
boot: knoppix xmodule=nv
Hi All,
as a newbie to Knoppix I am finding it very interesting but I have a problem I hope you can help with. When I boot (KNOPPIX_V3.2-2003-04-15-EN.iso), everything goes fine until the message AGP detected, at which point the system pauses for 3 to 4 minutes before continuing to a fully working system.
The system is a 600MHz Athelon with an AMD 751/756 chipset and a Vanta TNT graphics card.
Any help reducing this boot delay would be much appreciated.
Sounds like it takes a while to get your video card detected and drivers for it loaded. Vanta is Nvidia right and I assume that it IS in fact an AGP card? You could boot like this:
boot: knoppix xmodule=nv
Thanks for the suggestion, but it didn't help.
As I log out the text on the screen states the use of the NV module.
I'll try setting a persistant home to see if the system will pick up the settings from the last session.
Shaun

New Sealed Cisco C9300-NM-8X Network Switch Module - Tested Perfect Conditions
$380.00
Cisco WS-C3650-12X48UR-L 48-Port Stackable Layer 3 8x10G SFP+ Port Switch
$129.99
Cisco Catalyst C9120AXI-B Wi-Fi 6 Access Points
$36.00
Cisco Catalyst C9130AXI-B WiFi 6 802.11ax Wireless Access Point Brand New
$101.99
Lot of 500 Cisco 10-3145-02 QSFP-100G-CWDM4-S 100G CWDM4 QSFP28 Transceiver
$1500.00
Cisco | N3K-C3232C | 32-Port 100G QSFP Network Switch W/ 2x PSU, 2x Power Cords
$195.00
Cisco C9300-48UXM-A Switch 9300 Series 48-port UPoE Network
$874.99
Cisco C9300L-STACK-KIT V02 Stack
$170.00
$75.00
Cisco WS-C3850-12X48U-S 48-Port UPoE Switch 1100W PSU
$149.99