-
Senior Member
registered user
Can't Get USB Camera Working in 2.6.9
I've been trying to bring my 2.6.9 kernel up to full functionality in my Knoppix 3.7 HD installation.
I used to not even be able to boot to this kernel. But now that I've got it working, I want to switch from the 2.4 kernel to the 2.6.9.
I got my scanner working. Next stop the USB camera drive!
I turn the camera on while plugged into the USB port. I get this dmesg:
usb 4-2: new full speed USB device using address 6
scsi5 : SCSI emulation for USB Mass Storage devices
Vendor: Fujifilm Model: FinePix 1400Zoom Rev: 1000
Type: Direct-Access ANSI SCSI revision: 02
SCSI device sda: 256000 512-byte hdwr sectors (131 MB)
sda: Write Protect is off
sda: Mode Sense: 00 32 02 00
sda: assuming drive cache: write through
sda: sda1
Attached scsi removable disk sda at scsi5, channel 0, id 0, lun 0
So far so good.
So, then I add a line in my fstab like so:
/dev/sda1 /mnt/Camera users,noauto,rw 0 0
But I get this error message when I go to mount it:
mount: fs type rw not supported by kernel
In the 2.4.27 kernel the drive is seen as /dev/sdb1 and shows up just fine.
Any Linux experts out there know what I should do?
Am I playing with fire trying to get two kernels fully up to speed in Knoppix 3.7?
sakiZ
-
Senior Member
registered user
Can I remove the ub module in 2.6.9?
Ok, I found out why I can't use my usb camera in the 2.6.9 kernel: it's the ub module bug.
Underscore and others have written about this in this forum. This bug is one reason why Knoppix is not a good candidate for a HDD installation.
Anyway, can this module be removed? Or deactivated?
I'm reading that if you can do either one, usb-storage starts working again in the 2.6.9 kernel.
sakiZ
-
Senior Member
registered user
Disabled the ub driver Camera drive now appears.
OK,
I disabled the buggy ub driver in
/lib/modules/2.6.9/kernel/drivers/block/ub.ko
I renamed the ub.ko driver so that it now will not load.
I get nasty error messages now on boot up about this but now the camera drive shows up just fine as
/dev/sdb1 /mnt/Camera just like in kernel 2.4.27
Is there a cleaner way to disable this driver?
Underscore, are you out there?
sakiZ
Similar Threads
-
By e_cap in forum Hardware & Booting
Replies: 0
Last Post: 09-24-2008, 10:07 AM
-
By sakiZ in forum Tips and Tricks
Replies: 2
Last Post: 08-21-2006, 02:41 AM
-
By ZeroKun in forum The Lounge
Replies: 12
Last Post: 01-09-2005, 01:29 PM
-
By spydie in forum General Support
Replies: 14
Last Post: 01-31-2004, 07:55 PM
-
By wikes82 in forum Hardware & Booting
Replies: 3
Last Post: 07-09-2003, 10:34 PM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules

Polycom VVX 411 12-Lines Desktop VoIP Phone (2200-48450-025)
$20.00

Grandstream WP810 Portable Cordless Wi-Fi IP Phone
$54.99

YEALINK T34W PHONE & 2 MONTHS OF PHONE SERVICE
$65.00

Grandstream HT801 v2 1 FXS, 1 Fast Ethernet New Version
$34.99

Cisco CP-8861-K9 8861 VoIP IP Corded Phone Charcoal New 9 available
$118.00

Cisco/Linksys SPA2102 VoIP Phone Adapter Router 2FXS (Unlocked)
$17.99

*New* Yealink MP54-Teams Smart Business IP Phone, PoE, Touch Screen
$75.00

Cisco / Linksys SPA2102 VoIP 2FXS Phone Adapter with Router (unlocked)
$18.99

NEW Cisco IP Phone 7841-K9 4-Line VoIP Gigabit PoE CP-7841-K9
$49.95

Lot of 35 Polycom VVX 300 & VVX400 IP Phones
$150.00