|enouf|
I've been getting a bit suspicious of the DVD drive (BENQ), so borrowed another and swapped them. I was able to start Knoppix 4.02 OK running it from the replacement drive. So it seems the BENQ drive is flaky (as suggested in your last post). Anyway, I think I'll still follow your suggestion and install to HDD.
Thanks for all your help.
Bob
---
Verifying of md5 checksum and burning a CD at slow speed are important.
welcomeOriginally Posted by BobK_1905
To others reading.....The advice (suggestion) you refer to;
http://www.knoppix.net/forum/viewtop...=100659#100659
is not the a Real HDD install (it's not what Harry is warning against, AFAIK) - it's simply a way of booting the LiveCD Image while it's located on and runs from the HDD - rather than it being run and located on a physical Optical Disk (CD/DVD) -- again the 2 major advantages are (A) Speed (B) A Free ODD (Once Booted) for burning, listening to music, etc...
Thoughts Harry ?
The only caveat I can see offhand is that ntfs partitions may not 'cooperate" ?? (not sure - I don't use NTFS)..perhaps these ntfs issues are what prompted Gilles (Knoppix member ruymbeke) to create(?) the Win_Partition method (http://www.knoppix.net/wiki/Win_Partition) ?? I am unsure of this. Someone Please clarify, so I may halt any misinformation (on my part) from disseminating.
Booting the ISO from hard disk rask rather than after it is burnt to optical disc is indeed much safer. This has also been called the "Poor man's install", a term from back in the days when some hard disks were not large enough to hold the uncompressed Knoppix files and had to use the ISO on hard disk approach if they were going to go on hard disk at all. If all that is wanted is to boot Knoppix faster then this approach can give an improvement over booting from Optical media. But it also retains the limitations of the optical system; you stll have the Knoppix ISO in a read only system that can't be changed and installing extra software is not simple (although efforts to try should not break the original ISO and systems like Klik should work). But if one is going to go this far I feel that they should at least give a try to a real install of a real Debian system first. If you make the choice to go with a Poor Man's Install after trying Debian, that's a decision I can understand and respect (I could even understand that in some very strange circumstances one might choose to go for a full Knoppix hard disk install (sometimes called a fool Knoppix hard disk install). But I can't see any logic in tryng these approaches without at least looking at current installs of real Debian first.Originally Posted by |enouf|
---
Verifying of md5 checksum and burning a CD at slow speed are important.

Seagate ST6000NM0115 6TB 256MB 7200RPM 3.5" SATA 6.0Gb/s Enterprise Hard Drive
$159.99
Seagate Exos X14 10TB 7200RPM 3.5" SAS 12Gb/s Hard Drive HDD ST10000NM0528
$165.00
Seagate 14TB Exos X14 7200RPM SATA 6Gb/s 256MB 3.5" Enterprise HDD ST14000NM0408
$354.99
Seagate Exos X16 ST10000NM010G 10TB 7200RPM SAS 12Gb/s 3.5" 512e/4Kn HDD
$199.00
Seagate ST500DM009 BarraCuda 500 GB 3.5" SATA III Desktop Hard Drive
$14.99
HGST HUS724040ALA640 4TB 7200 RPM SATA 3.5" Internal Desktop Drive 100% Health
$78.00
Dell ST91000640SS 1TB 2.5" 6Gb/s 64MB 7.2K RPM SAS Hard Drive Dell P/N: 0VXTPX
$16.99
Seagate Barracuda 3TB 3.5" HDD 7200RPM 64MB SATA 6Gb/s ST3000DM001 Tested
$49.99
MG08SCA16TE Toshiba 16TB 7.2K SAS 12gb/s 512e 3.5inch HDD HDEPN10GEA51 NEW
$454.44
Western Digital HUS726T4TAL5204 4TB 7.2K SAS 12Gb/s 3.5" 512e HDD NetApp X375A
$69.00