Hi , i have tired to run kismet in my laptop Dell latitiude D510

with orinoco gold card

im using whoppix 2.7 & the kismet version 2005,01,R1a

the orinoco run when boot cd ( eth0,eth1,eth2)

i use code :

show-wireless-interface.sh
found :
eth2
-----------------------

I try to read about it many time , they said make sure kismet.conf is configured correctly

i dont no how i configure it !
then i check the kismet.conf
-----------
# Kismet config file
# Most of the "static" configs have been moved to here -- the command line
# config was getting way too crowded and cryptic. We want functionality,
# not continually reading --help!

# Version of Kismet config
version=2005.01.R1a

# Name of server (Purely for organiational purposes)
servername=Kismet

# User to setid to (should be your normal user)
suiduser=kismet

# Sources are defined as:
# source=sourcetype,interface,name[,initialchannel]
# Source types and required drivers are listed in the README.
# The initial channel is optional, if hopping is not enabled it can be used
# to set the channel the interface listens on.
# YOU MUST CHANGE THIS TO BE THE SOURCE YOU WANT TO USE

#source=orinoco,eth1,kismet
source=wlanng,wlan0,Prism
#source=kismet_drone,192.168.2.252:3501,kismet_dro ne

# Comma-separated list of sources to enable. This is only needed if you defined
# multiple sources and only want to enable some of them. By default, all defined
# sources are enabled.
# For example:
# enablesources=prismsource,ciscosource

# Do we channelhop?
channelhop=true

# How many channels per second do we hop? (1-10)
channelvelocity=5

----------------------------------------
i try to change it but when i close & return its came back
what should i change in kismet.conf & how i configured & save it ?????
can any one help me to do it step by step
i now its an old version but its work fine with me only the problem
with kismet ......