I have the same card as the person in the previos post, and I posted a soluton to his delema, however I would like to get my belkin card working with ver 5.0

Essentially, the driver will install with ndiswrapper, but when finished, it tells me that although the driver is installed, the hardware is not present or something like that. I've already run both "Wavelan configuration" and "Network Card Configuration"

I've entered my essid and wep encryption key e.t.c. (yes I've made sure the key and essid are correct)

Here are the results of just a few of the many commandline entries I've made (with their results):

eth0 IEEE 802.11b/g ESSIDff/any Nickname:"Broadcom 4318"
Mode:Managed Access Point: Invalid Bit Rate=1 Mb/s
RTS thrff Fragment thrff
Encryption keyff
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

sit0 no wireless extensions.

root@1[knoppix]# ifconfig

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:24 errors:0 dropped:0 overruns:0 frame:0
TX packets:24 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:1200 (1.1 KiB) TX bytes:1200 (1.1 KiB)

root@1[knoppix]# pump -i eth0
Operation failed.

root@1[knoppix]# ifconfig eth0 up
SIOCSIFFLAGS: No such file or directory

root@1[knoppix]# ndiswrapper -l
Installed ndis drivers:
bcmwl5a driver present
rt2500 driver present

root@1[knoppix]# ndiswrapper -m
modprobe config already contains alias directive

root@1[knoppix]# ndiswrapper -d PCIID:wlan0 bcmwl5a

Driver 'bcmwl5a' is used for 'PCIID:WLAN0'

I've tried removing the rt2500 driver as well, and alternated trying the bcmwl5a driver with no good results.

NOTE: This card will install under version 4.02 no problems (Both Live CD and Hard drive install)

I've tried to install the card on ver 5.0 live CD with the same results I'm getting on the hard drive install that I'm currently trying to get it working on.

I'm guessing it's just some simple script edit that needs to be done, but I really don't know what else to do.

I've scoured the forums for similar problems, and tried some suggested fixes for possibly similar problems with slightly different equipment with no luck.

Would appreciate any help at all.

Regards Mikejo