-
Back again!
first things first.
motherboard
Code:
Motherboard Properties:
Motherboard ID 63-0201-000010-00101111-091605-945PL$A0355000_BIOS DATE: 09/16/05 11:07:08 VER: 08.00.10
Motherboard Name ASUS P5PL2
Front Side Bus Properties:
Bus Type Intel NetBurst
Bus Width 64-bit
Real Clock 200 MHz (QDR)
Effective Clock 800 MHz
Bandwidth 6400 MB/s
Memory Bus Properties:
Bus Type Dual DDR2 SDRAM
Bus Width 128-bit
Real Clock 267 MHz (DDR)
Effective Clock 533 MHz
Bandwidth 8533 MB/s
Chipset Bus Properties:
Bus Type Intel Direct Media Interface
NIC; (only one!)
Code:
Realtek RTL8168/8111 PCI-E Gigabit Ethernet NIC ]
Network Adapter Properties:
Network Adapter Realtek RTL8168/8111 PCI-E Gigabit Ethernet NIC
Interface Type Gigabit Ethernet
Hardware Address 00-15-F2-08-0F-ED
Connection Name Local Area Connection
Connection Speed 100 Mbps
MTU 1500 bytes
DHCP Lease Obtained 30/09/2006 12:33:52
DHCP Lease Expires 01/10/2006 12:33:52
Bytes Received 49832832 (47.5 MB)
Bytes Sent 2858125 (2.7 MB)
Network Adapter Addresses:
IP / Subnet Mask 192.168.1.2 / 255.255.255.0
Gateway 192.168.1.1
DHCP 192.168.1.1
DNS 192.168.1.1
ok,
i booted up knoppixand tried using other ip addresses for the computers ip address. when i then tried to ping the outside world i simply got the message network not found. One thing i did notice when knoppix was booting up was after it found eth0,it brought up the message "DHCP broadcasting for ip (backgrounding)" (dont know if thats pertinent or not)
so i then re-booted knoppix and started ethereal (as root) before i ran netcardconfig. ethereal could not find eth0 at all, so i quit the application and ran netcardconfig. This time ethereal found eth0 so i started the capture process. Nothing happened until i tried to ping to ping 216.32.81.146. ethereal gave a few lines of the following;
Code:
source destination protocol info
(blank) (blank) ARP (malformed packet)
at this point the only thing i could think to do was to try and reconfigure my NIC to use DHCP, this gave a few lines of the following;
Code:
source destination protocol info
0.0.0.0 255.255.255.255 DHCP DHCP Discovery Transaction ID 0x69140600
ethereal then quit itself complaining that it could not find eth0
So i'm not sure where to go from here, any suggestions?
Thanks in advance.
Similar Threads
-
By ladyarcher44 in forum Networking
Replies: 0
Last Post: 12-21-2006, 10:56 PM
-
By Jorge Martínez in forum Networking
Replies: 1
Last Post: 07-07-2006, 11:27 PM
-
By compgeek in forum Networking
Replies: 10
Last Post: 01-06-2006, 10:52 PM
-
By Josh in forum Networking
Replies: 5
Last Post: 02-24-2005, 05:17 AM
-
By Sance in forum General Support
Replies: 2
Last Post: 12-06-2004, 10:27 PM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules

MegaRAID 9580-8i8e 16-port 12G SAS/SATA/NVMe 8GB PCIe RAID - 05-50076-00
$1619.19

G-Technology G-SPEED Studio XL 48TB Thunderbolt 2 Storage - Housing Only
$200.00

Broadcom MegaRAID 9480-8e Fujitsu PRAID EP540e SAS RAID Card (Replac 9380-8e) 8i
$228.00

Intel VROC Premium RAID Controller Card PCIe Add-On Module VROCPREMMOD
$265.00

Broadcom LSI 9305-16i 12Gbps SAS-3 PCIe x8 HBA 16-Ports Raid Controller
$64.99

Dell PowerEdge HBA330 LP PCI-E 12GBs RAID SAS Controller Adapter J7TNV
$18.95

OWC Mercury Elite Pro 2 Bay RAID Enclosure with USB 3.2 for Dual 3.5 inch HDDs
$87.99

NVME M.2 Adapter Card PCIE X16 Splitter Expansion Controller 4-Disk Soft RAID
$24.43

Broadcom 9600-24i RAID Controller PCIe Gen 4.1 Tri-Mode NEW 05-50111-01004
$649.99

Areca ARC-1882IX-24 (16i4e)24-Port RAID Controller Card w/BBU /HDD Monitor Board
$300.00