-
Booting problem - crc error
I have just burnt boot disc from KNOPPIX_V5.1.1CD-2007-01-04-EN.iso after checking the md5 as in faq.
However I have been unable to boot from the disc. I reburnt it at 2x speed and made sure burnt iso image etc, this was done from OSX. The disc itself seems fine however when debug is turned on knoppix fails when uncompressing linux.
I have tried a whole combination of boot options, with failsafe and debug I get the following:
Loading linux...........................................
Loading minirt.gz..........................
Ready.
Uncompressing Linux...
crc error
-- System halted
I am trying to get it going on Vaio notebook PCG VGN-FS660/W which wont boot XP for as yet an unknown reason, but may be a failed hardrive.
I noticed in some earlier posts, over 2 years, that the thinking on this sort of crc error is that the live cd has probably got a bad sector on it. If this is the case is there a way of checking this out? Unfortunately I don't have access to another cd burner or pc to test out.
Any ideas welcome
Thanks
poirot
decompressing linux at which point I get the crc error
-
Administrator
Site Admin-
Sounds like you are indeed burning the disc as an iso, or you would not have got as far as you did.
You mention that the pc you are trying to boot on will no longer boot xp, and that maybe it is a hard disk failure. Maybe it's not the hard disk at all, maybe there is a memory failure (or some other basic system component). Try booting and at the boot prompt type memtest. Let it run a few passes of memtest86 to be sure the system is up to running anything.
-
Youre right. Just did the memtest, and not one pass just watching the errors stack up!
At least that means the hard disc is probably recoverable!
Many thanks.
-
Administrator
Site Admin-
Thanks for the confirmation. You seemed to have done a proper job making the disc, so when I couldn't account for how you would have a crc error I guessed that memory was bad, causing it.
Hope your disk is ok. If the memory failed hard and fast after windows was shut down then it may well be, but if the memory went bad while windows was writing the disk then you could have some problems.
---
Verifying of md5 checksum and burning a CD at slow speed are important.
Similar Threads
-
By delfin13 in forum MS Windows & New to Linux
Replies: 2
Last Post: 01-08-2010, 07:09 PM
-
By buji_ryu in forum Hardware & Booting
Replies: 1
Last Post: 04-19-2007, 04:01 PM
-
By a_r_m in forum Hardware & Booting
Replies: 3
Last Post: 12-23-2005, 05:53 PM
-
By BasK in forum Hardware & Booting
Replies: 6
Last Post: 08-26-2005, 11:45 PM
-
By jason25 in forum General Support
Replies: 6
Last Post: 09-13-2004, 12:17 PM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules

Broadcom LSI 9305-16i 12Gbps SAS-3 PCIe x8 HBA 16-Ports Raid Controller
$64.99

Broadcom 9600-24i Tri-Mode RAID Controller 4.0 NVMe SAS SATA NEW 05-50111-01003
$639.69

G-Technology G-SPEED Studio XL 48TB Thunderbolt 2 Storage - Housing Only
$200.00

HP controller P3410-69003 NetRAID-1M SCSI 64-bit U160 32MB Cache (PCI)
$359.00

OWC Mercury Elite Pro Quad 4 Bay RAID Storage Enclosure USB 3.1 Gen 2 No Drives
$149.95

LSI 9260-8i 512MB SAS SATA 8-port PCI-E 6Gb RAID Controller Card US
$29.88

OWC Mercury Elite Pro 2 Bay RAID Enclosure with USB 3.2 for Dual 3.5 inch HDDs
$87.99

Dell PowerEdge HBA330 LP PCI-E 12GBs RAID SAS Controller Adapter J7TNV
$22.99

BROADCOM 05-50077-01 PCI-E 4.0 x8 PCI-Express MegaRAID 9560-8i RAID Controller
$714.99

Dell PowerVault MD3000i AMP01 Storage Array 2x PSUs No HDDs/Controllers/Caddies
$144.95