-
Here is the latest output after WINDOWS XP usage for USB non-show and non-mount:
usb 1-1: USB disconnect, address 2
sda : READ CAPACITY failed.
sda : status=0, message=00, host=7, driver=00
sda : sense not available.
sda: Write Protect is off
sda: Mode Sense: 00 00 00 00
sda: assuming drive cache: write through
sda : READ CAPACITY failed.
sda : status=0, message=00, host=7, driver=00
sda : sense not available.
sda: Write Protect is off
sda: Mode Sense: 00 00 00 00
sda: assuming drive cache: write through
ohci_hcd 0000:00:13.0: auto-wakeup
usb 1-1: new full speed USB device using ohci_hcd
and address 3
usb 1-1: configuration #1 chosen from 1 choice
scsi1 : SCSI emulation for USB Mass Storage devic
es
usb-storage: device found at 3
usb-storage: waiting for device to settle before
scanning
scsi 1:0:0:0: Direct-Access JetFlash TS1GJF11
0 0.00 PQ: 0 ANSI: 2
SCSI device sda: 2047999 512-byte hdwr sectors (1
049 MB)
sda: Write Protect is off
sda: Mode Sense: 00 00 00 00
sda: assuming drive cache: write through
SCSI device sda: 2047999 512-byte hdwr sectors (1 049 MB)
sda: Write Protect is off
sda: Mode Sense: 00 00 00 00
sda: assuming drive cache: write through
sda: unknown partition table
sd 1:0:0:0: Attached scsi removable disk sda
usb-storage: device scan complete
knoppix@Knoppix:~$ sudo mount sda
mount: can't find sda in /etc/fstab or /etc/mtab
knoppix@Knoppix:~$ mount sda
mount: can't find sda in /etc/fstab or /etc/mtab
knoppix@Knoppix:~$
so it seems to be to my unknowing eye, the partition table problem as you mentioned.
so from here,
using
knoppix@Knoppix:~$sudo mc
I edited etc/fstab to also include this line
/dev/sda/ media/sda auto rw,users,exec 0 0
and etc/mtab
/dev/sda /media/sda auto rw,nosuid,nodev 0 0
in my persistent knoppix.image and booted from bootfrom=/dev/hda1/home/downdirectory/K*.iso
and then restart knoppix before a changed occurred and I was able to then use the USB flash drive normally.
Because this fail to mount USB doesnt happen every time I use Windows XP, it may be also connected to which service pack is installed in windows XP and also which version of internet expolrer is being used.
For the record, the last machine used before the USB plugging problems started in knoppix5.1.1 were Internet Explorer 7 on Windows XP service pack2
Similar Threads
-
By Albretch in forum Hardware & Booting
Replies: 0
Last Post: 10-14-2006, 01:52 AM
-
By Albretch in forum Hdd Install / Debian / Apt
Replies: 0
Last Post: 03-14-2006, 03:25 AM
-
By passion_wheel1974 in forum Hardware & Booting
Replies: 0
Last Post: 04-18-2005, 11:06 PM
-
By phsieh in forum General Support
Replies: 2
Last Post: 12-14-2004, 06:23 PM
-
By shaun in forum Hdd Install / Debian / Apt
Replies: 4
Last Post: 06-26-2003, 10:52 PM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules

HP 2x 10GB OPNsense Quad Core i5-8500 8GB RAM 3Port Gigabit Firewall AES-NI SSD
$199.95

OPNsense Firewall 16-Core Atom C3958 16GB DDR4 RAM 64GB SSD 8x 1Gbe QAT AES-NI
$195.00

Check Point 1590 Firewall & w builtin WiFI and builtin LTE sim slot
$95.99

Barracuda NextGen CloudGen Cloud Based Firewall F280 BNGF280a w/ 8.3.1 Firmware
$89.99

OPNsense pfSense 8-Core Atom C3758 2.2GHz 8GB DDR4 64GB SSD 8x NIC QAT AES VPN
$145.00

Fortinet FortiGate 60F FG-60F UTM UTP License Until 2027 Network Security FW VPN
$218.49

Sophos XG 210 Rev. 3 Firewall Appliance – 8GB RAM / 128GB SSD – Tested & Reset
$149.99

Palo Alto PA-220 Next-Gen Firewall 520-000309-00J
$40.00

Zero Trace Pen: All-in-one Tor Network Anonymous Drive + Cryptocurrency Wallet
$99.00

HPE Networking Instant On Secure Gateway Smart-Managed Switch (S0G33A#ABA) - New
$269.99