How to get KSensors to Work

First do the following at link below.
http://www.knoppix.net/forum/viewtopic.php?t=4639

Second do the following code:


Code:
apt-get -t unstable install ksensors
apt-get install hddtemp
apt-get install i2c-source lm-sensors lm-sensors-source

Third - go to /usr/src and move lm-sensors.tar.gz to /home/knoppix/tmp

DON'T EXTRACT lm-sensors.tar.gz IN /usr/src !!!

Also don't use lm-sensors from there Web Site, it is missing some i2c modules - use apt-get install lm-sensors-source !

Fourth - Copy lm-sensors to /usr/local and Compile: make all | su to root and make install

Fifth - Run sensors-detect [root] - Follow direction's, don't worry if it can't load some modules (Say no to i2c-riva, NEVER load it - it will Screw up your Kernel) at the end it will give directions to get modules to load after rebooting.

Sixth - Configure KSensors to show temps, voltages, etc. IF they don't show, try
insmod i2c-dev or modprobe i2c-dev - OR/AND rerun sensors-detect and at:
If you have the choice, do you want to use the ISA bus or the
I2C/SMBus (ISA/smbus)?

Select ISA (NOTE: If you have no ISA slots like my motherboard - There STILL is an ISA BUS
on you Motherboard !!!)

Mine is running OK ...