Thanks Forester,

I put the firmware in lib/firmware, I seen wlan0, but I can't connect to it:

# cat /mnt/sdc1/AfterFirmware.txt
knoppix@Microknoppix:~$ iwconfig
lo no wireless extensions.

eth0 no wireless extensions.

eth1 no wireless extensions.

wlan0 IEEE 802.11bgn ESSIDff/any
Mode:Managed Access Point: Not-Associated Tx-Power=20 dBm
Retry long limit:7 RTS thrff Fragment thrff
Power Managementff

knoppix@Microknoppix:~$ ifconfig
eth0 Link encap:Ethernet HWaddr 00:15:e9:2d:eb:fb
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:18 Base address:0x2800

eth1 Link encap:Ethernet HWaddr 80:00:60:0f:e8:00
inet addr:169.254.2.2 Bcast:169.254.2.255 Mask:255.255.255.0
inet6 addr: fe80::8200:60ff:fe0f:e800/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:21 errors:6 dropped:11 overruns:0 frame:0
TX packets:8 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1889 (1.8 KiB) TX bytes:1504 (1.4 KiB)

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:1863 errors:0 dropped:0 overruns:0 frame:0
TX packets:1863 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:121153 (118.3 KiB) TX bytes:121153 (118.3 KiB)

wlan0 Link encap:Ethernet HWaddr 00:26:f2:f6:ca:76
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)

knoppix@Microknoppix:~$


I tried to connect to it using iwconfig, similar to what is show at:
http://www.knoppix.net/wiki/Network_...ppix_5.1.1_FAQ

knoppix@Microknoppix:~$ iwconfig wlan0 essid MYWIRELESSROUTER channel 5
Error for wireless request "Set ESSID" (8B1A) :
SET failed on device wlan0 ; Operation not permitted.
knoppix@Microknoppix:~$
#

Channel 5 is what I'm using in puppy linux.

-Charlie