Do not run wireshark as user "root"!
Read some documentations about wireshark. Your problem isn't a Knoppix problem.
When I launch wireshark(from k-menu..run, or from the command line) it loads but doesn't list interfaces unless I do sudo wireshark or I suppose if I do su then wireshark. That's fine.
But sudo wireshark or su<ENTER>wireshark<ENTER> isn't working.
It worked yesterday but now when I try, I get this error
knoppix@Microknoppix:~$ su root
root@Microknoppix:/home/knoppix# wireshark
No protocol specified
(wireshark:4986): Gtk-WARNING **: cannot open display: :0
root@Microknoppix:/home/knoppix# su knoppix
knoppix@Microknoppix:~$ sudo wireshark
No protocol specified
(wireshark:503: Gtk-WARNING **: cannot open display: :0
knoppix@Microknoppix:~$
Do not run wireshark as user "root"!
Read some documentations about wireshark. Your problem isn't a Knoppix problem.
Thanks. I got it to work since some days back. For the record it was most likely this solution that I used
http://ask.wireshark.org/questions/7...erfaces-listed
$ sudo apt-get install wireshark
$ sudo dpkg-reconfigure wireshark-common
$ sudo usermod -a -G wireshark $USER
$ sudo reboot

Dell PowerEdge M630 Blade Server 2x Xeon E5-2680 v4, 2F3MP , 4GDP5 ,R10KJ ,JVFVR
$96.60
Cisco UCS 5108 Blade Server Chassis Enclosure N20-C6508 4x PSU 8x Fans 2x Fabric
$174.99
Dell PowerEdge M640 Blade Barebone Server Dell P/N: HHB006 Tested Working
$149.99
ASUS Blade Server LAN Web Remote Management KVM Module Chip IPMI 2.0 ASMB9-iKVM
$49.99
Supermicro 4U 32x 3.5 Bays 4-Nodes | 8x E5-2660 v3 2.6Ghz | 64gb RAM | 9207-8i
$699.99
NETAPP HCI NAF-1701 SuperMicro Server 4X BLADE H410C 8X GOLD 5120 4 NODE SERVER
$1499.97
Dell PowerEdge FX2 FX2s Server 10GbE CMC Blade Enclosure Chassis
$274.99
Dell PowerEdge FX2 FX2s Server 10GbE CMC Blade Empty Chassis XJ6VP
$149.99
AS IS READ DESCRIP. Supermicro SuperServer 6026TT-HIBQRF 12-Bay 4x X8DTT-HIBQF
$215.00
NEW Cisco UCSB-5108-AC2 Blade Server Chassis 8 Slot 6RU Chassis 4 X PSU - DW
$599.40