Results 1 to 5 of 5

Thread: Motherboard does not post...

  1. #1
    Junior Member registered user
    Join Date
    Mar 2003
    Location
    Austin TX
    Posts
    24

    Motherboard does not post...

    I changed the CPU fan on my athelon XP 2000, now my mobo doesint post! Seems like the CPU is fine coz each time I power on the heatsink gets warm and the CPU fan is spinning. The motherboard seems to be healthy coz all the LEDs light up and my PCI cards seem to be getting power (I know this coz the fan on my radeon is working) The speaker makes a click noise, but does not beep.

    I tried unplugging everything leaving the RAM, CPU on it, still no beeps. even took it out of the case. Still no luck.... I even tried reseating the RAM and the CPU still same result. I also disconnected the BIOS battery and put it back in after 3 -5 mts .. no luck...

    Did I fry something?? Is there a way to verify if my mobo and CPu are still healthy?

    Any suggestions??

  2. #2
    Senior Member registered user
    Join Date
    Mar 2003
    Location
    colorado springs, colorado
    Posts
    1,933
    You'd need to leave the CMOS battery out a little longer usually to reset the CMOS. There might be a jumper on your mobo to reset the CMOS and NVRAM with which would be much faster than removing the battery and waiting. Are you sure you didn't accidentally knock a power connector off the mobo when you were inside the case? Checked all of your connections?

    If none of the above works remove everything you can from your box (sound, NIC, etc.)and try to run with minimal hardware installed.

  3. #3
    Junior Member registered user
    Join Date
    Mar 2003
    Location
    Austin TX
    Posts
    24
    I am not sure if resetting the BIOS will do any good, anyways I am desprate and so will try that.

    I already tried a minmum boot, with CPU and RAM only, but no luck...

  4. #4
    Junior Member registered user
    Join Date
    Jul 2003
    Location
    Middle of Nowhere
    Posts
    10
    Try pulling out the RAM and if you get beeps, more than likely your system is still alive.

    L J

  5. #5
    Junior Member registered user
    Join Date
    Jun 2003
    Posts
    12

    Re: Motherboard does not post...

    A few motherboards have an interlock between the CPU HS/F riser and the fan itself so that if the fan stops working, the motherboard shuts down before the CPU is fried. Perhaps yours is one of those motherboards and PERHAPS your new CPU fan is connected to a different header, or is not compatible with this scheme. As a way to rule this out, temporarily reinstall the old HS/F in the old place and see if it boots that way.

    Quote Originally Posted by manjo
    I changed the CPU fan on my athelon XP 2000, now my mobo doesint post! Seems like the CPU is fine coz each time I power on the heatsink gets warm and the CPU fan is spinning. The motherboard seems to be healthy coz all the LEDs light up and my PCI cards seem to be getting power (I know this coz the fan on my radeon is working) The speaker makes a click noise, but does not beep.

    I tried unplugging everything leaving the RAM, CPU on it, still no beeps. even took it out of the case. Still no luck.... I even tried reseating the RAM and the CPU still same result. I also disconnected the BIOS battery and put it back in after 3 -5 mts .. no luck...

    Did I fry something?? Is there a way to verify if my mobo and CPu are still healthy?

    Any suggestions??

Similar Threads

  1. IBM Motherboard Problem
    By bd in forum Hardware & Booting
    Replies: 1
    Last Post: 01-18-2005, 09:38 PM
  2. Knoppix doesn't like my new motherboard
    By tuxtaxdani in forum General Support
    Replies: 11
    Last Post: 02-25-2004, 04:01 PM
  3. Can Knoppix run on ECS motherboard?
    By rubensava in forum General Support
    Replies: 0
    Last Post: 02-20-2004, 03:29 AM
  4. Change of Motherboard
    By Doc in forum Hardware & Booting
    Replies: 1
    Last Post: 09-16-2003, 12:50 AM
  5. Viewing motherboard temperatures
    By pummer in forum General Support
    Replies: 11
    Last Post: 09-13-2003, 06:08 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


SFP TO RJ45 TRANSCEIVER SFP MODULE COPPER SFP OPTICAL PORT TO RJ45 ETHERNET PORT picture

SFP TO RJ45 TRANSCEIVER SFP MODULE COPPER SFP OPTICAL PORT TO RJ45 ETHERNET PORT

$7.99



NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping* picture

NEW Sealed Cisco SFP-10G-LR 10GBASE-LR SFP+ 1310nm 10km *US Shipping*

$24.00



Qty 20 New Cisco QSFP-100G-FR-W2 10-3659-01 Module Hologram Brand New 20 Pack picture

Qty 20 New Cisco QSFP-100G-FR-W2 10-3659-01 Module Hologram Brand New 20 Pack

$260.00



For Cisco SFP-10G-T-X Module, 10G SFP to RJ-45 Copper, 10GBase-T, 1/2.5/5/10Gbps picture

For Cisco SFP-10G-T-X Module, 10G SFP to RJ-45 Copper, 10GBase-T, 1/2.5/5/10Gbps

$39.99



Cisco SFP-10G-SR Transceiver picture

Cisco SFP-10G-SR Transceiver

$4.00



Intel X520-DA2 10Gb 10Gbe 10 Gigabit Network Adapter NIC Dual Port E10G42BTDA picture

Intel X520-DA2 10Gb 10Gbe 10 Gigabit Network Adapter NIC Dual Port E10G42BTDA

$28.94



10Gb SFP+ to RJ45 Module Copper Cat6 Transceiver Compatible w/5Gb/ 2.5Gb/ 1Gb picture

10Gb SFP+ to RJ45 Module Copper Cat6 Transceiver Compatible w/5Gb/ 2.5Gb/ 1Gb

$31.95



*LOT OF 10*Cisco SFP-GE-T EXT 30-1421-01 USA 1000BASE-T RJ45 SFP Transceiver picture

*LOT OF 10*Cisco SFP-GE-T EXT 30-1421-01 USA 1000BASE-T RJ45 SFP Transceiver

$19.99



30PCS Sealed Cisco SFP-10G-SR 10GBASE-SR SFP+ Transceiver Module MMF 850nm 300m picture

30PCS Sealed Cisco SFP-10G-SR 10GBASE-SR SFP+ Transceiver Module MMF 850nm 300m

$499.99



New Sealed Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Transceiver Module *US picture

New Sealed Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Transceiver Module *US

$17.00