Yesterday I thought I had crashed two computers after using knopix. One was a Dell Dimension, the other a Dell Optiplex.

On rebooting after using knoppix exactly nothing happened! The computers seemed to be very dead. More dead than I've ever seen before, actually.

Quite scary, as none of the computers were mine.

Turns out that the problem was easy to fix, I just had to pull out the power cable for a few seconds, so everything is fine now.

But I REALLY REALLY REALLY think this problem should be in the FAQ/Documentation! (with large print..)

Dell is a very common brand, and this problem might actually give knoppix a bad reputation.

Other than that, knoppix rocks!!