After getting the appropriate modules (from Mandrake 9.2) for my Promise SATA150TX4, KNOPPIX now recognizes my Raptor hard drive. At the CD's boot prompt, I use:

knoppix modules-disk

After loading the three required module files from floppy, the Raptor is detected and I can access its partitions.

I've run the included installer scripts and everything seemed to complete without any problems. Unfortunately, I cannot boot the HD installation because the modules files needed to recognize the hard drive weren't added to the initrd.

How can I modify the post-install initrd to add the necessary module files? Per this thread, can someone like Fabian help?

**KEEP IN MIND, if I have to recreate the entire initrd, what modules are already included so I don't forget to keep them in the initrd?

Thanks in advance.

-SUO

Older related posts:
http://www.knoppix.net/forum/viewtopic.php?t=5487
http://www.knoppix.net/forum/viewtopic.php?t=5551