Monitor recognition

[Delbor]

Hi there,

my monitor is connected to my PC via a BNC-cable. During startup of knoppix no DDC-information is retrieved and standard monitor settings apply.

The "right" monitor name would be "ENC1613" (aka EIZO T761), is there any way to pass this to Knoppix as a startup parameter?

Delbor

[knixkw]

perhaps one of the following cheatcodes will help:

screen=1280x1024 Use specified Screen resolution for X
xvrefresh=60 or vsync=60 Use 60 Hz vertical refresh rate for X
xhrefresh=80 or hsync=80 Use 80 kHz horizontal refresh rate for X

example (type at boot prompt):
knoppix screen=1024x768 vsync=75

Attention: Use only refresh rates Your EIZO will survive.

see also http://www.knoppix.net/docs/index.php/CheatCodes

I don't know a direct way to pass the monitor name to Knoppix.