no sound with Knoppix 3.3

[fingers99]

According to

http://www.rme-audio.com/english/linux/alsa.htm

Hammerfall is supported in Alsa. Odd.

I'd not be surprised if sndconfig (which is for pretty much obsolescent soundcards) couldn't handle it.

If we're talking (as I'm begining to suspect) about a Hard Drive install, you should run

alsa_init

But, in the meantime, please do post your lspci -v output.

[raapie]

I did:
lspci -v > pcifile

at root

and then

cat pcifile

it did show info, but I thought it would create a txt-file. where can I find it?

it shows this text about the RME:
(03:00.0 Multimedia audio controller: Xilinx Corporation RME Hammerfall DSP (rev0b)

Flags: stepping, medium devsel, IRQ3
Memory at 20800000 (32 bit, non-prefetchable) [size=64k]

Is that useful?

THanks a lot for your help so far! I am sure I will start making some music on Linux one day

Oh... I am running from CD-rom and didn't do an installation (need to clean up the junk on my harddrives etc..)

[fingers99]

To find the whole file (what you've posted doesn't mean a lot to me, but, then, I'm sure the whole lot will to someone) do this:

su
updatedb
locate pcifile

You can then pop up pdifile in (say) gvim:

gvim pdifile

left mouse click and drag to highlight the lot, move the cursor to one of these boxes and (depending on 3 button or 2 button mouse) either middle button click or both-buttons-at-once click.

[windos_no_thanks]

I did:
lspci -v > pcifile

at root

and then

cat pcifile

it did show info, but I thought it would create a txt-file. where can I find it?

it shows this text about the RME:
(03:00.0 Multimedia audio controller: Xilinx Corporation RME Hammerfall DSP (rev0b)

Flags: stepping, medium devsel, IRQ3
Memory at 20800000 (32 bit, non-prefetchable) [size=64k]

Is that useful?

THanks a lot for your help so far! I am sure I will start making some music on Linux one day

Oh... I am running from CD-rom and didn't do an installation (need to clean up the junk on my harddrives etc..)

pcifile IS the .txt file in Linux (and Unix in general) the file names don't have to end in a certain way to be a certain type of file (even tough they often do)
Just do a "mv pcifile pcifile.txt" to make windoze understand what it is. (Some applications in windoze might still not understand the line separation though)

[Markus]

Well, at least the card is detected.

Have you tried sound with headphones, I remember reading about some trouble with digital speakers if you'd happen to have such.

According to:
http://www.alsa-project.org/alsa-doc...dor-RME#matrix
all but "Hammerfall DSP MADI" are supported by alsa.

PS: the pcifile was created in the directory where you ran the command.

[windos_no_thanks]

Might be some other hardware that gets detected as the audio device.
The full output of "lspci -v" (pcifile) will show us if that is the case.

[raapie]

both partitions on my Sony laptop are of NTFS. I couldn't copy the pcifile to the second partition... I tried my desktop, couldn't copy the file either even on my fat32 partition. I don't know why. Anyway, my desktop has a floppy-disk so I copied it on that one (my laptop doesn't have a floppy disk by the way, so I am out of luck on that box...). so here's the pcifile:

00:00.0 Host bridge: Intel Corp. 440BX/ZX/DX - 82443BX/ZX/DX Host bridge (rev 03)
Subsystem: Asustek Computer, Inc.: Unknown device 8024
Flags: bus master, medium devsel, latency 64
Memory at d0000000 (32-bit, prefetchable) [size=256M]
Capabilities: [a0] AGP version 1.0

00:01.0 PCI bridge: Intel Corp. 440BX/ZX/DX - 82443BX/ZX/DX AGP bridge (rev 03) (prog-if 00 [Normal decode])
Flags: bus master, 66Mhz, medium devsel, latency 64
Bus: primary=00, secondary=01, subordinate=01, sec-latency=64
Memory behind bridge: cc800000-cddfffff
Prefetchable memory behind bridge: cdf00000-cfffffff

00:04.0 ISA bridge: Intel Corp. 82371AB/EB/MB PIIX4 ISA (rev 02)
Flags: bus master, medium devsel, latency 0

00:04.1 IDE interface: Intel Corp. 82371AB/EB/MB PIIX4 IDE (rev 01) (prog-if 80 [Master])
Flags: bus master, medium devsel, latency 32
I/O ports at d800 [size=16]

00:04.2 USB Controller: Intel Corp. 82371AB/EB/MB PIIX4 USB (rev 01) (prog-if 00 [UHCI])
Flags: bus master, medium devsel, latency 32, IRQ 5
I/O ports at d400 [size=32]

00:04.3 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ACPI (rev 02)
Flags: medium devsel, IRQ 9

00:09.0 Multimedia audio controller: Xilinx Corporation RME Hammerfall DSP (rev 32)
Flags: bus master, stepping, medium devsel, latency 32, IRQ 5
Memory at cc000000 (32-bit, non-prefetchable) [disabled] [size=64K]

00:0b.0 FireWire (IEEE 1394): Lucent Microelectronics FW323 (rev 04) (prog-if 10 [OHCI])
Subsystem: Pinnacle Systems Inc.: Unknown device 000e
Flags: bus master, medium devsel, latency 32
Memory at cb800000 (32-bit, non-prefetchable) [disabled] [size=4K]
Capabilities: [44] Power Management version 2

00:0d.0 Multimedia audio controller: Yamaha Corporation: Unknown device 1000
Subsystem: Yamaha Corporation: Unknown device 1000
Flags: bus master, stepping, slow devsel, latency 32, IRQ 5
Memory at cb000000 (32-bit, non-prefetchable) [disabled] [size=256K]

00:0e.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
Subsystem: Compex FN22-3(A) LinxPRO Ethernet Adapter
Flags: bus master, medium devsel, latency 32, IRQ 10
I/O ports at d000 [size=256]
Memory at ca800000 (32-bit, non-prefetchable) [size=256]
Expansion ROM at <unassigned> [disabled] [size=64K]
Capabilities: [50] Power Management version 2

01:00.0 VGA compatible controller: Matrox Graphics, Inc. MGA G400 AGP (rev 04) (prog-if 00 [VGA])
Subsystem: Matrox Graphics, Inc. Millennium G400 MAX/Dual Head 32Mb
Flags: bus master, medium devsel, latency 64, IRQ 11
Memory at ce000000 (32-bit, prefetchable) [size=32M]
Memory at cd000000 (32-bit, non-prefetchable) [size=16K]
Memory at cc800000 (32-bit, non-prefetchable) [size=8M]
Expansion ROM at cdff0000 [disabled] [size=64K]
Capabilities: [dc] Power Management version 2
Capabilities: [f0] AGP version 2.0

[windos_no_thanks]

Hmm, looks like there is another audio device present:

00:0d.0 Multimedia audio controller: Yamaha Corporation: Unknown device 1000
Subsystem: Yamaha Corporation: Unknown device 1000
Flags: bus master, stepping, slow devsel, latency 32, IRQ 5
Memory at cb000000 (32-bit, non-prefetchable) [disabled] [size=256K]

What modules are loaded ?
(do "lsmod > modules.txt" for instance)

[raapie]

it's a non-supported Yamaha SW1000xg

[windos_no_thanks]

it's a non-supported Yamaha SW1000xg

I'm not sure but I suppose it could still make the auto-detect fail.
Seeing if the module for Hammerfall is loaded or not would be helpful.