Knoppix 3.3 only creates one partition with the ext3 f

[Uwe Brauer]

Hello

Right now I am still running SuSe 8.2 with the following hard
disk configuration
/dev/hda6 7341440 5870408 1471032 80% /
/dev/hda8 1172672 723876 448796 62% /home

/dev/hda6 on / type reiserfs (rw)
/dev/hda8 on /home type reiserfs (rw)

Hda7 is the swap partition.

Now I wanted not to touch this partitions but to install
knoppix on hda6 with reiserfs.


I booted the
New Knoppix release V3.3-2003-11-19
everything went fine.

The installation program seems to me knoppix installer run as root, I
can then have a look at the configuration and the hard disk partition,
everything is fine, but when I select install, knoppix offers me to
install the system on hda6 with ext3, no option for reiserfs!!!

Additionally a message occurs that /hda7 and /hda8 will be used as
swap, which is not what I want /dev/hda8 is my home directory.

What did I miss?

Thanks

Uwe Brauer

[fingers99]

Which installer are you using?

[Uwe Brauer]

Which installer are you using?

I did not emphasize enough:
knoppix-installer


I did not find any other, I heard about harddisk installer or so, but this I did not
find on the CD

[windos_no_thanks]

knx-hdinstall is the other one, it supports reiserfs

[Uwe Brauer]

knx-hdinstall is the other one, it supports reiserfs

thanks

ok i try that one just wondering why the knoppix installer is nice but so restrictive,

[kelmo]

Knoppix-installer is the better script in my opinion. When you use it it tells you that some setting can only be changed by editing a saved configuration file.
Run the script, configure the installation and then save it.
Navigate to /home/knoppix and edit the file with a text editor.
Change filesystem type to reiser, default=ext3. Swap config can be altered although knoppix does this automattically at boot up anyway.

[Uwe Brauer]

Knoppix-installer is the better script in my opinion. When you use it it tells you that some setting can only be changed by editing a saved configuration file.
Run the script, configure the installation and then save it.
Navigate to /home/knoppix and edit the file with a text editor.
Change filesystem type to reiser, default=ext3. Swap config can be altered although knoppix does this automattically at boot up anyway.

Hello,

thanks for this one.
I could give this a try, but I also prefer always to have a /home partition apart, I presume
this can be done also.
Still I think it would be best if both installers could be merged, or just to add to the
knoppix installer the possibilty of chosing the partition and their type.
It is a little strange to have to nice installers but both are not perfect, but could be enhanced
as it seems to me easily.