Knoppix 3.2 wont see my network

[Harry Kuhman]

IP eth0:192.168.0.1

I'm not sure what adress range D-Link defaults to (different routers use slightly different ranges). However, this is wrong. If your documentation tells you to connect to the D-Link at this address then this is the right address for the d-link, but it's not what you use here. You need to assign another address in the same range (192.168.0.1 is one of only 3 or 4 addresses in the range that you can't use, because the outer is using it). I like to start at an address like 192.168.0.100, but you could really pick any address in this range except 192.168.0.0, 192.168.0.1 or 192.168.0.255 and maybe 192.168.0.254

Network Mask eth0:255.255.255.0

Yea, looks good

Broadcast Address eth0:192.168.0.255

Yup, again right if the router is at 192.168.0.1

Default Gateway:192.168.0.254

Nope, the gateway should be the router address: 192.168.0.1

Nameserver:192.168.0.254

Nope, what you need here is the address of a Domain Name Server, and I'm sure you don't have one locally at this address. Your ISP should have provided you with a DNS address. I could have sworn I could check what this setting was under Windows, but I just looked to try to find it and can't locate any place to find it (it's not in the control panel ethernet settings or in ipconfig), so I'm at a loss to tell you where to set this to unless you can get a good value from your ISP. It will not be a 192.168.xxx.xxx adress, it will likely be an IP address in your IPS assigned address range.